NXP TDA1002x: Difference between revisions

From LinuxTVWiki
Jump to navigation Jump to search
(Boldface defined term. Mv editing note to talk.)
 
(5 intermediate revisions by one other user not shown)
Line 1: Line 1:
The '''NXP TDA1002x''' range are [[DVB-C]] [[demodulator]]s from [[NXP Semiconductors|NXP]] (previously [[Philips]]).
A [[DVB-C]] [[Demodulator]] used e.g. in the Philips CU1216 Tuner Module. The TDA10021 has been derived from the [[VLSI VES1820]] and thus both designs seem to be quite similiar.

== NXP TDA10021 ==
A DVB-C Demodulator used e.g. in the Philips CU1216 Tuner Module. The TDA10021 has been derived from the [[VLSI VES1820]] and thus both designs seem to be quite similar.


Documentation is available only when signing an [[NDA]].
Documentation is available only when signing an [[NDA]].
Line 5: Line 8:
A Linux driver exists.
A Linux driver exists.


== NXP TDA10023HT ==
[[Category:DVB-C]]
The TDA10023HT is a single-chip DVB-C channel receiver for 4, 16, 32, 64, 128 and 256 QAM modulated signals. The device interfaces directly to the IF signal, which is sampled by a 10-bit ADC inside the TDA10023HT.

[[Category:Demodulator]]
[[Category:Demodulator]]
[[Category:DVB-C]]

Latest revision as of 07:40, 18 December 2016

The NXP TDA1002x range are DVB-C demodulators from NXP (previously Philips).

NXP TDA10021

A DVB-C Demodulator used e.g. in the Philips CU1216 Tuner Module. The TDA10021 has been derived from the VLSI VES1820 and thus both designs seem to be quite similar.

Documentation is available only when signing an NDA.

A Linux driver exists.

NXP TDA10023HT

The TDA10023HT is a single-chip DVB-C channel receiver for 4, 16, 32, 64, 128 and 256 QAM modulated signals. The device interfaces directly to the IF signal, which is sampled by a 10-bit ADC inside the TDA10023HT.