Pinnacle PCTV nano Stick (73e)
It is advertised as specially sensitive and thus able to capture weak signals, but not in moving environments such as cars. My experience is that the sensitivity of reception/reception quality is comparable to PCI DVB-T cards such as the TwinhanDTV Digital Terrestrial TV Card Ter. In any case it's a neat device - very compact, which is also true for its remote control.
Note that this USB sticks requires a USB 2.0 slot (USB 1.1 is not enough, as according to the driver, the USB stick does not have a hardware PID filter, i.e. the data stream is of the order of 8 MB/s which is too much for USB 1.1).
For older kernels, the stick does not work with standard Linux distribution kernel drivers, but installation of v4l-dvb is not difficult (see below "Driver Compilation and Installation"). For kernel versions 18.104.22.168 and higher (and probably some earlier ones, too), the standard Debian distro kernel image identified and loaded the drivers correctly, but I had to install the firmware (see below "Firmware Installation").
First check we're talking about the same piece of hardware:
$lsusb -v (...) Bus xxx Device yyy: ID 2304:0237 Pinnacle Systems, Inc. [hex] Device Descriptor: (...) idVendor 0x2304 Pinnacle Systems, Inc. [hex] idProduct 0x0237
Driver Compilation and Installation
If your distro kernel does not have the drivers included, you have to download and compile the driver v4l-dvb to get it running, but that's only a few command lines.
Install mercurial and linux-kernel-headers. In Debian-related systems like Ubuntu this is:
sudo apt-get install dvb-utils mercurial build-essential linux-headers-$(uname -r)
And then in any system:
hg clone http://linuxtv.org/hg/v4l-dvb cd v4l-dvb hg update -C 4501 make sudo make install
You can now restart your computer, but for me it worked to just do:
sudo modprobe -v v4l-dvb
You can test whether the driver is running with
where you should get something, and not a "No such file...".
If you plug in the USB stick and get an error message like "firmware not found", you have to download the firmware:
cd /lib/firmware sudo wget http://www.wi-bw.tfh-wildau.de/~pboettch/home/linux-dvb-firmware/dvb-usb-dib0700-1.10.fw
This downloads one file into the /lib/firmware directory. Now plug in the stick again, and it should load fine (without the "firmware" error message), i.e. you get an adapter0 if you do
Sources: This is where I got these tricks from -- thanks guys:
- more lengthy/complicated (involves getting firmware, which at least in Ubuntu 8.04 is not necessary):
According to this documentation on a french speaking ubuntu wiki, this device contains the DiBcom 7000 chipset and works as expected with the corresponding drivers.
Also here from Linux-dvb mailing list, probably works http://marc.info/?l=linux-dvb&m=121310115902841&w=2