TechniSat SkyStar HD
Jump to navigation
Jump to search
A DVB-S2 PCI card by TechniSat.
Experimental support exists.
Overview
Apparently the card is actually a rebranded TechnoTrend TT-budget S2-3200.
02:06.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
Subsystem: Technotrend Systemtechnik GmbH Unknown device 1019
Flags: bus master, medium devsel, latency 32, IRQ 20
Memory at feaffc00 (32-bit, non-prefetchable) [size=512]
# lspci -v -n -s 02:06.0
02:06.0 0480: 1131:7146 (rev 01)
Subsystem: 13c2:1019
Flags: bus master, medium devsel, latency 32, IRQ 20
Memory at feaffc00 (32-bit, non-prefetchable) [size=512]
output from lspci -vvv
01:00.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
Subsystem: Technotrend Systemtechnik GmbH Unknown device 1019
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 10
Region 0: Memory at e9cffc00 (32-bit, non-prefetchable)[size=512]
modules
You need to
modprobe stb6100 stb0899 saa7146 lnbp21 modprobe budget-ci
If you don't load the other modules first, you'll get
DVB: Unable to find symbol stb6100_attach()
As with all DVB drivers, if you don't see any cards and frontends in multiproto's menuconfig, enable I2C in your kernel config and in multiproto do make distclean afterwards.
Components Used
- STMicroelectronics STB6100 (tuner ... found under the tin can)
- STMicroelectronics STB0899 (a "C2L" revision) (demodulator)
- NXP/Philips SAA7146 (PCI bridge)
It also supports an add-on CI slot.