[linux-dvb] Starting DVB

[Tomasz Viscardi <tviscard@inwarz.skierniewice.pl>]

    [ The following text is in the "iso-8859-2" character set. ]
    [ Your display is set for the "ISO-8859-1" character set.  ]
    [ Some characters may be displayed incorrectly. ]

Hello,
I try to start dvb services under linux.
I have kernel 2.2.15( I did upgrade from 2.2.5 to compile dvb driver).
After compiling driver and make insmod I have dvb0 intrface :
dvb0      Link encap:Ethernet  HWaddr 00:D0:5C:5B:8F:CB
          inet addr:192.168.4.1  Bcast:192.168.4.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100    
My plan is to share dvb connection in my LAN using dvbd started on
linux.
But when I start dvbd with dvb.conf :
# DVB receiver configuration file, (c) 2000 data planet international
# standard location in /etc
# LNB power on=1/off=0
power 1
# symbol rate [symbol/sec]
symbolrate 22000000
# ASTRA TR 114
frequency 12640000
# 22 kHz signal on=1/off=0
ttk 1
# diseqc on=1/off=0
diseqc 0
# AFC on=1/off=0
AFC 1
# polarisation H=1/V=0
polarisation 0
# settings for MPE filter, PID and MAC filtering, valid MAC bytes
filter_0 512
filter_1 785 00:D0:5C:1E:96:01 48
filter_2 786 00:D0:5C:1E:96:01 48
filter_3 1041 00:D0:5C:1E:96:01
48                                                      It happens
nothing. I don't see dvbd process running.
In SAT - HOWTO it was written that after running dvbd without parameters
I should see connection quality.
Are my setting correct ?
BTW is there any manual for setting dvbd ?
Regards,
Tomasz Viscardi


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.