[linux-dvb] AW: RGB signal

["Manfred Schmidt-Voigt" <Manfred.schmidt-voigt@mannitec.de>]

hello List,

is there somebody who has experience with such "some hardware" ? Any tips
how to solve it? I think only some resistors are not enough. It should be
something with knobs to calibrate the three RGB signals.

Regards
Manfred


> -----Ursprungliche Nachricht-----
> Von: linux-dvb-bounce@linuxtv.org
> [mailto:linux-dvb-bounce@linuxtv.org]Im Auftrag von Ralph Metzler
> Gesendet: Montag, 29. Oktober 2001 12:09
> An: manfred.schmidt-voigt@bigfoot.de
> Cc: Linux-Dvb
> Betreff: [linux-dvb] RGB signal
>
>
> Manfred Schmidt-Voigt writes:
>  > Hello driverdevelopers,
>  >
>  > since 1 hour I have now a cable for the J2 connector to my
> LOEWE TV set. I
>  > use the RGB signal. The pictures are realy great with this
> connection. Full
>  > of brilliance. But there is always a "but". My TV set is not able to
>  > regulate the colors any more with the RGB input because the
> signal is feed
>  > directly to the video part of the TV behind all regulators.
>  >
>  > Now my question: Is it possible with your driver to choose a
> signal strenght
>  > for the J2 connector by a driver parameter during module load?
>
>
> No, I have no influence on the signal strengths of the RGB pins.
> If the signal levels are too high or low for your TV set
> I guess you will have to add some hardware to adjust this.
>
>
> Ralph
>
>

--
-------                   Manfred Schmidt-Voigt                  -------
-----                  Gunzweg 10, 22393 Hamburg                   -----
-----                                                              -----
-------          mailto:manfred.schmidt-voigt@mannitec.de         -------




-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.