[linux-dvb] Re: DEC2000-T model 70013 ?

[Marco Kraus <marco@kraus.tk>]

On Thursday 07 October 2004 14:03, Alex Woods wrote:

> > I modified the kernelmodule that 70013 was taken as the DEC2000-T.
> > But (except the error message disappears of course) this comes up:
> > --- cut ---
> > usb 3-1: bulk timeout on ep4in
> > ttusb_dec_send_command: result bulk message failed: error -110
> > usbcore: registered new driver ttusb-dec
> > --- cut ---
>
> Is this all of the messages you get with the modified module?  It suggests
> it's dieing even before it's tried to load the firmware.  Have you tried
> powering off the dec for a minute or so then powering it on again?

After I turned off the box for some time, restarted all services and so on, it 
now registeres correctly. Of course I still needed to add the modelversion to 
the kernel-module to use it as a DEC2000-t.

> > Any ideas how to go on ? Anyone using model 70013 ?
> > Do I have a chances to get this beast running ?
>
> All very good questions, I'm afraid - it's the first I've heard of this
> model ;(

It seems that this is the "new" hardware of the DEC2000 which is announced 
at the Hauppauge website some weeks ago. But it should run now with your 
kernelmodule (and model 70013 modifications), I hope. 

I now try to get a videostream from the box, to see if everything is right.
I'll mail you after some test this afternoon

Oh, and the new DEC2000 also seems to be the DEC2540-t, what confused me
a little bit ;-)

--- cut --
usb 3-1: new full speed USB device using address 2
ttusb_dec: Firmware 1.21de
ttusb_dec: found DSP code "DEC2540-t".
usbcore: registered new driver ttusb-dec
usb 3-1: USB disconnect, address 2
usb 3-1: new full speed USB device using address 3
DVB: registering new adapter (DEC2000-t).
DVB: registering frontend 0:0 (TechnoTrend/Hauppauge DEC2000-t Frontend)...
--- cut ---

See you.
-- 
 Marco

 - Die Revolution sagt: ich war, ich bin, ich werde sein -