[linux-dvb] Re: B2C2/Technisat Cable/Air/SkyStar USB

[Holger Waechtler <holger@qanu.de>]

Patrick Boettcher wrote:

> On Sun, 31 Oct 2004, Holger Waechtler wrote:
>  
> > Have you found out how the LNB supply is connected? There are basically
> > 2 obvious options: either the STV0299 OP0/OP1 pins or pins of the
> > FlexCop. Maybe there even exists some code you can reuse.
> >    
> No, I don't have the device here, yet, the pictures are the only thing I
> have currently.
>
> How do figure it out LNB supply pins? Following the lines on the board
> from the connector to a IC?
>  
Either this way (if OP0/OP1 are connected somewhere then you should 
investigate this connection mor in detail), or by protocol sniffing the 
USB traffic of the windows driver, or by analyzing the windows driver 
binary.

Holger