[vdr] Re: error with dxr3 and vdr 1.1.20

[Simeon Walker <simeon@sbs.bangor.ac.uk>]

On Saturday 01 Feb 2003 5:44 pm, Sven Soltau wrote:
> Am Sam, 2003-02-01 um 18.22 schrieb Simeon Walker:
> > On Saturday 01 Feb 2003 5:17 pm, Sven Soltau wrote:
> > > Hello,
> > >
> > > I have trouble with my hollywood+ and vdr 1.1.20 with dxr3-0.1.4.
> > > When I start vdr I always get the following message/error.
> > >
> > > vdr:dxr3abstractiondevice.c:54: cDxr3AbsDevice::cDxr3AbsDevice():
> > > Assertion `(m_fdVideo=open("/dev/em8300_mv",01))>=0` failed
> > >
> > > Can anybody help me?
> > >
> > > My system: Abit BE6-II, Celeron 300A @ 450 Mhz, 128 MB-SDRam, Siemens
> > > DVB-S 1.3, Hollywood+, VDR 1.1.20, DXR3-0.1.4
> > >
> > > I have installed
> > > em8300-0.13 and ffmpeg-0.4.6
> > > To /etc/modules.conf I added:
> > >
> > > alias char-major-121 em8300
> > > pre-install em8300 modprobe adv717x
> > > post-install em8300 em8300setup
> > > options adb717x pixelport_16bit=1 pixelport_other_pal=0
> >
> > is the above line correct?
>
> I hope so. How can I check it?
>

well it says 'options adb717x...' instead of 'options adv7171x'

> > > options em8300 dicom_fix=0 dicom_control=0 dicom_other_pal=0
> > >
> > > What am I doing wrong? Any hints?
> >
> > I saw this once, I think it was when I forgot to run
> > em8300setup after reloading some modules.
> >
> > Are you absolutley sure that the modules are loaded and
> > that em8300setup has run?
>
> How can I check this?
>
when you do' modprobe em8300' you should see the output
from the em8300setup program. Run em8300setup manually to
see what I mean.

> THX
> Sven
>

Regards,
Simeon

-- 
Simeon Walker,                      email: simeon@sbs.bangor.ac.uk
School of Biological Sciences,      phone: +44 (0)1248 383702
University of Wales, Bangor,        fax: +44 (0)1248 382569
Gwynedd, LL57 2UW, UK.              www: http://biology.bangor.ac.uk/



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.