[vdr] Re: VDR developer version 1.1.23

[Gerald Raaf <graaf@attglobal.net>]

Klaus Schmidinger schrieb:

> Gerald Raaf wrote:
> >
> > Hi Klaus,
> >
> > vdr-1.1.23 and the ll-dvb driver 02.02.2003 didn't work well with my equipment.
> > HW 3Hauppauge DVB-S Cards:
> > DVB0 Nexus 2.1
> > DVB1 DVB-S 1.3
> > DVB2 DVB-S 1.3 -> the Cam is at this card so i can watch to FTA channels when recording
> >
> > with this i get the following problems:
> > when i tune to a PW channel, i can view it for about 1 minute then the picture freeze,
> > and i have to restart vdr. If i restart vdr with a tuned PW channel this channel is
> > viewed after restart, when i then tune to another PW-channel nothing more is shown on
> > TV (black screen).
> > FTA channels works everytime.
> >
> > if I put the Cam to the Nexus Card (DVB0) i can zap as often i want between FTA and
> > Crypted channels, and all works well. But i don't want to connect the cam to my primary
> > card, because then i can't watch FTA channels -> why because i comment out the
> > DO_REC_AND_PLAY.... and DO_MULTIPLE... because this didn't work well -> vdr crashes
> > when recording.
> >
> > when i use the driver from 12.08.2002 from your page everthing works fine regardless to
> > which DVB Card the Cam module is connected.
>
> Could you connect a tv set to the DVB2 card to see whether the picture also freezes
> on _that_ card? Your observation may be caused by the recent problems with replay
> of some recordings (especially from RTL channels, but maybe also others). In your
> configuration I assume CA channels will be watched in Transfer Mode, which essentially
> is the same as replaying.
>
> Klaus
>

@Klaus,

i have connect yet all my DVB cards to the av receiver so i can switch with the av-receiver
and can take a look at all outputs of the DVB card including audio. But i think its not vdr
its the dvb driver because when i watch CA channels with driver from 12.08, vdr-1.1.23 works
in Transfer Mode.
to your question:
- watching CA channels will be done in Transfer Mode
- the picture is also frozen.

I have installed the AC3OverDVB patch 0.1.2 from Stefan, and did the tests again.
the behavior is the same. Picture is frozen but it takes about 15 minutes.

I got the same messages like Johannes Lautner described (today 21:24).

But as i said i will use the driver from 12.08.2002, with this one it works.

I've seen in the system.log the message "kernel: BUFFER EMPTY" everytime the picture freeze,
i can find this message in the log.

Gerald



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.