[vdr] dxr3 doesn't work anymore (partially)

[Stefan Lucke <stefan@lucke.in-berlin.de>]

Hi,

I noticed that my dxr3 card dosen't work anymore.
There is the following kernel message upon vdr start:

May  4 08:27:21 bodega1 kernel: em8300_video.o: Video sync interrupted

and vdr stops with: segmentation fault.

Video out only works during key teaching phase when I remove remote.conf.

Some hours before that happend I had the following messages in syslog (I don'
know if that is related to my problem):

Mai  2 21:46:48 bodega1 vdr[717]: Streamdev: Receiver thread started (pid = 717)
Mai  2 21:47:10 bodega1 vdr[464]: cDxr3AbsDevice::Resuscitation Device failure detected
May  2 21:47:11 bodega1 kernel: bt865.o: Configuring for PAL
May  2 21:47:11 bodega1 kernel: em8300_audio.o: Analog audio enabled
May  2 21:47:11 bodega1 kernel: em8300: Microcode version 0x29 loaded
Mai  2 21:47:11 bodega1 vdr[464]: cDxr3AbsDevice::Resuscitation Micro code upload successfully
Mai  2 21:47:11 bodega1 vdr[464]: cDxr3AbsDevice::Resuscitation Reopening devices took 1
May  2 21:47:11 bodega1 kernel: em8300_audio.o: Digital PCM audio enabled

What microcode is upload at that point and where does it come from ?

-- 

mfg

  Stefan Lucke (stefan@lucke.in-berlin.de)


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.