[vdr] Re: CAM-Alphacrypt 2.0 - AOT_CA_INFO_ENQ

["Martin Binder" <martin_binder@compuserve.com>]

> -----Original Message-----
> From: vdr-bounce@linuxtv.org [mailto:vdr-bounce@linuxtv.org]On Behalf Of
> Martin Binder
>  
> Hi,
> 
> since i have updated the Alphacrypt-CAM from SW 1.10 to Rev. 2.0 
> i the CAM obviously doesnt react fast enough on a 
> AOT_CA_INFO_ENQ, thus no encryption is done.
> 
> If the smartcard ist reinserted the CAM_INFO is available and 
> encryption works ok. As a workaround I have disabled the line 
> 
>  state = 1;
> 
> in "bool cCiConditionalAccessSupport::Process".
> 
> Then it is not necessary to reinsert the smartcard, as VDR tries 
> to get the CA_INFO until it gets it and encryption is done fine. 
> (Although it sometimes lasts up to 15 secs till CAM is full enabled).
> 
> Maybe there is a better solution for that, as i don't know if 
> there are any other side effects, if "state" is not set to 1. As 
> said before, it works fine here, but maybe someone who 
> understands this whole CA/CI-stuff better than me, can look at this.
> 
> Thanks
> 
> Martin
> 
Sorry, i forgot to mention:

DVB-driver: 2003-05-24
VDR-1.1.33/plain
configuration:
1 Grundig DVB-S 1.6 (primary card)
1 Hauppauge Nova-S 
1 Hauppauge DVB-S 2.1, CI-Slot 3,5" Rev. 1.6 (2x Alphacrypt SW2.0)



-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.