[linux-dvb] freecom dvb-t usb firmware coldstate

[Mike Choy]

Hi Team

Still struggling with tuning this card.

I noticed that  when this card is pluged in, it is recognised as a  
Freecom card.
But when the firware is loaded it first disconnects, and reconnects as a 
Wideview.
Is this normal?

================Output from 
dmesg=================================================

usb 3-5: USB disconnect, address 3
dvb-usb: WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U) 
successfully deinitialized and disconnected.
usb 3-5: new high speed USB device using ehci_hcd and address 4
dvb-usb: found a 'WideView WT-220U PenType Receiver (Typhoon/Freecom)' 
in cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-wt220u-01.fw' to the 
'Cypress FX2'
dvb-usb: WideView WT-220U PenType Receiver (Typhoon/Freecom) 
successfully initialized and connected.
usb 3-5: USB disconnect, address 4
dvb-usb: generic DVB-USB module successfully deinitialized and disconnected.
usb 3-5: new high speed USB device using ehci_hcd and address 5
dvb-usb: found a 'WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 
(WT-200U)' in warm state.
dvb-usb: will use the device's hardware PID filter (table count: 15).
DVB: registering new adapter (WideView/Yuan/Yakumo/Hama/Typhoon DVB-T 
USB2.0 (WT-200U)).
DVB: registering frontend 1 (WideView USB DVB-T)...
dvb-usb: schedule remote query interval to 300 msecs.
dvb-usb: WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U) 
successfully initialized and connected.
dvb-usb: recv bulk message failed: -110

Mike Choy
http://www.acaciaclose.co.uk
The home of SUSE Multimedia