[linux-dvb] Re: Fujiplus FD-3250 (Twinhan VP-3250?) Support - Additional Info

Bryan Scott sirbryan at gmail.com
Sat Dec 3 19:56:08 CET 2005


Forgot to mention I'm using kernel 2.6.14.3 with  v4l-dvb cvs from last 
night.


Bryan Scott wrote:
> I've scoured the bttv and linux-tv lists for as much info as I could
> find about the FujiPlus FD-3250.  Linux (bttv) sees it as a Twinhan
> VisionPlus clone, but then dst complains it can't find a DST with the
> error message(s) included below.
> 
> Other messages suggest it may use a different set of tuners than most
> Twinhan's since it's an ATSC/NTSC card with Antenna and Cable F
> connectors.
> 
> Any status on patches or specific modules I should be paying attention
> to to load this thing?  I'm so close I can almost feel it!  :)
> 
> -- Bryan
> 
> bt878: AUDIO driver version 0.0.0 loaded
> bt878: Bt878 AUDIO function found (0).
> bt878(0): Bt878 (rev 17) at 00:0b.1, irq: 18, latency: 32, memory: 0xdddfe000
> DVB: registering new adapter (bttv0).
> rdc_8820_reset: Resetting DST
> dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0000]
> dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0004]
> dst_comm_init: Initializing DST.
> dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000]
> rdc_reset_state: Resetting state machine
> dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0000]
> dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0002]
> writing [ 00 06 00 00 00 00 00 fa ]
> write_dst: _write_dst error (err == -5, len == 0x08, b0 == 0x00)
> dst_error_recovery: Trying to return from previous errors.
> dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000]
> dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000]
> write_dst: _write_dst error (err == -5, len == 0x08, b0 == 0x00)
> dst_error_recovery: Trying to return from previous errors.
> dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000]
> dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000]
> write_dst: RDC 8820 RESET
> dst_error_bailout: Trying to bailout from previous error.
> rdc_8820_reset: Resetting DST
> dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0000]
> dst_gpio_outb: mask=[0004], enbb=[0004], outhigh=[0004]
> dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000]
> dst_probe: unknown device.
> frontend_init: Could not find a Twinhan DST.
> dvb-bt8xx: A frontend driver was not found for device 109e/0878
> subsystem 1822/0                      001
> 



More information about the linux-dvb mailing list