[linux-dvb] dvb-bt8xx: A frontend driver was not found for device 109e/0878 subsystem 1822/0001

Manu Abraham abraham.manu at gmail.com
Thu Dec 29 08:54:55 CET 2005


Artem wrote:

>On Wednesday 28 December 2005 19:07, you wrote:
>
>With dst_algo I din't cheking becouse they load modue dst automaticly. 
>  
>
This shouldn't be an issue, i will explain ..

># wget 
>"http://83.110.18.182:8000/cgi-bin/hgwebdir.cgi/v4l-algo-test?cmd=archive;node=675755d11eb289dc063d4fc3fcc0e7503bbd5928;type=bz2"
># tar jxfv 
>v4l-algo-test\?cmd\=archive\;node\=675755d11eb289dc063d4fc3fcc0e7503bbd5928\;type\=bz2
># cd cgi-bin-hgwebdir-cgi-v4l-algo-test-675755d11eb2/
>make 
>make install
>
>  
>

-- snip --

>0xd3001000
>: DVB: registering new adapter (bttv0).
>: dst_get_device_id: Recognise [DST-03T]
>:
>: DST type flags : 0x2 ts204 0x4 symdiv 0x10 firmware version = 2
>: dst_get_mac: MAC Address=[00:08:ca:16:5e:00]
>: DVB: registering frontend 0 (DST DVB-S)...
>
>Now It's looks good.
>
>./scan -l C-BAND Yamal201
>scanning Yamal201
>using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
>initial transponder 3645000 H 28000000 5
>initial transponder 3645000 V 28000000 5
>  
>
>>>>tune to: 3645:h:0:28000
>>>>        
>>>>
>0x0000 0x000b: pmt_pid 0x0064 Gascom -- Kultura dubl-1 (running)
>0x0000 0x000c: pmt_pid 0x00c8 Gascom -- Kultura dubl-2 (running)
>0x0000 0x000d: pmt_pid 0x012c Gascom -- NTV (running)
>0x0000 0x000e: pmt_pid 0x0190 Gascom -- TNT (running)
>0x0000 0x000f: pmt_pid 0x01f4 Gascom -- DTV +7 (running)
>0x0000 0x0010: pmt_pid 0x0258 Gascom -- TV3 (running)
>0x0000 0x0011: pmt_pid 0x02bc Gascom -- Sport (running, scrambled)
>
>I'm typing to config xawtv but they say fontend not locked. 
>
>  
>

Thanks, for testing the hw_algo stuff. I will take a look as to why the 
hw_algo is no functioning as expected.

>kernel: dvb_frontend_thread: using FE_ALGO_HW
>last message repeated 46 times
>
>  
>
The dst module needs to have dst_algo as a module parameter to change 
the tuning algorithm, hw/sw.
If your module is getting loaded automatically, you can make the 
necessary changes to modprobe.conf, to change the module parameter.
This should solve your problem temporarily, since hw_algo is more 
effecient for the dst, rather than s/w.


Manu




More information about the linux-dvb mailing list