[linux-dvb] tda1004x update

Michael Krufky mkrufky at m1k.net
Tue Nov 8 19:20:56 CET 2005


Hartmut Hackmann wrote:

> Hi, Michael
>
> Michael Krufky wrote:
>
>> Hartmut Hackmann wrote:
>>
>>> I just committed an update of the tda1004x dvb-t driver to the 
>>> dvb-kernel
>>> CVS. It only affects the tda10046 (hopefully):
>>>
>>> - fixed oddities at firmware download from eeprom.
>>> - more tolerant vs crystal frequency offset. It should now work with up
>>>   to -/+100ppm deviation. This can be the cause why some boards like
>>>   the Lifeview just didn't work for some users.
>>> - lower sampling clock to 48Mhz for low IF and 53MHz for 36MHz. 
>>> Together
>>>   with some other minor changes, this increases the sensitivity a bit.
>>> - doesn't touch the GPIOs any longer. This needs to be handled by the
>>>   board layer.
>>>
>>> The latter change might cause incompatibilities. However, it is 
>>> necessary
>>> since the pins are used very differently. I could not find problems 
>>> with
>>> boards i have access to. 
>>
>>
>>
>> Hartmut-
>>
>> What is the status of the testings with this patch?  Your 
>> announcement mentions some possible incompatabilities...
>>
>> Mauro has already send your v4l patches to -mm... Do they depend on 
>> this one?
>>
>> -Michael Krufky
>>
> Hi, Michael
>
> I haven't heard anything but few reports that it gave the slight 
> performance
> improvement i expected.
> I tested with 4 different cards: Lifeview, Philips Tiger and Europa 
> and the
> Medion. The Philips cards are at least compatible with the Compro and 
> the ASUS.
> I can get hands on one other important card in short term.
> So there is quite some test coverage.
> The GPIO thing can cause trouble with modern hybrid cards like the 
> ASUS which
> need proper handling of the GPIOs.
>
> Hermann, can you roll back the tda1004x driver to see whether the old 
> version
> works with your card?
>
> This went a bit fast. I didn't expect that Mauro would update the patches
> again...
>
> Hartmut

Hartmut-

Would you mind joining Mauro and I in #v4l on irc.freenode.net ?

We would just like to discuss the situation with your patches and 
whether the v4l patch depends on the dvb counterpart, etc.... Whether or 
not it is safe for me to send the dvb portion of the patch to akpm, or 
if Mauro should ask akpm to drop the v4l portion until it can get more 
testing, etc.

We both will be in #v4l today, as we are both regularly found in that 
chat room.  If not today, then tomorrow or the next day.....  OR, just 
email us back to let us know the status, but a quick chat would be nice.

Thanks,

Michael Krufky





More information about the linux-dvb mailing list