[linux-dvb] BBC HD TS file

[Soyeb Aswat]

Hello Nico,

I've been trying this for days and just can't get it working:

soyeb at linux:~/dvb/hd> decode_pat city.ts

New PAT
  transport_stream_id : 47976
  version_number      : 17
    | program_number @ [NIT|PMT]_PID
    |              1 @ 0x42 (66)
  active              : 1

soyeb at linux:~/dvb/hd>
soyeb at linux:~/dvb/hd> decode_pmt city.ts 1 66

New active PMT
  program_number : 1
  version_number : 8
  PCR_PID        : 0x45 (69)
    | type @ elementary_PID
    | 0x03 (ISO/IEC 11172 Audio) @ 0x44 (68)
    |  ] 0x0a : "eng"
    | 0x1b (ISO/IEC 13818-1 reserved) @ 0x45 (69)

New active PMT
  program_number : 1
  version_number : 11
  PCR_PID        : 0x46 (70)
    | type @ elementary_PID
    | 0x03 (ISO/IEC 11172 Audio) @ 0x46 (70)
    |  ] 0x0a : "eng"

New active PMT
  program_number : 1
  version_number : 12
  PCR_PID        : 0x47 (71)
    | type @ elementary_PID
    | 0x03 (ISO/IEC 11172 Audio) @ 0x46 (70)
    |  ] 0x0a : "eng"
    | 0x1b (ISO/IEC 13818-1 reserved) @ 0x47 (71)



soyeb at linux:~/tmp/dvbstream> ./dvbstream -c 1 -f 522167000 -tm 8 -o 0 66
68 69 > stnhsth
dvbstream v0.6 - (C) Dave Chapman 2001-2004
Released under the GPL.
Latest version available from http://www.linuxstb.org/
Tuning to 522167000 Hz
Using DVB card "KWorld/VStream XPert DVB-T", freq=522167000
tuning DVB-T (in United Kingdom) to 522167000 Hz, Bandwidth: 8
Getting frontend status
Bit error rate: 0
Signal strength: 65481
SNR: 43433
UNC: 0
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI
FE_HAS_SYNC
dvbstream will stop after -1 seconds (71582788 minutes)
Output to stdout
Streaming 4 streams
Caught signal 2 - closing cleanly.
soyeb at linux:~/tmp/dvbstream> ls -l stnhsth
-rw-r--r--  1 soyeb users 19740 2006-08-03 16:16 stnhsth
soyeb at linux:~/tmp/dvbstream>

That file obviously doesn't contain anything useful in there.  Can you
see what I'm doing wrong?

Also I don't have a problem capturing the full TS, I use VLC for that
and it works fine.  It's just that, because there is more than one
channel there, mencoder gets confused and falls over :-(  Any
suggestions on a workaround?  By the way, this all works on another
channel that we have that only has one channel in the TS.

Thanks,

Soyeb