[linux-dvb] SS2 2.6D: no frontend driver found for this B2C2/FlexCop adapter

[Nico Sabbi]

Brendan White wrote:

> SkyStar2 TV version 2.6D
> gentoo amd64
> 2.6.14
>
> I've tried stock 2.6.14 drivers, linuxtv stable snapshot, and the  
> most recent daily snapshot.  I've tried the card in different slots.   
> All yield the same results.  The frontend driver modules do load,  
> they just dont seem to do anything useful:
>
>
> b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip  
> loaded successfully
> flexcop-pci: will use the HW PID filter.
> flexcop-pci: card revision 2
> ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
> ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [APC4] -> GSI 19 (level,  
> low) -> IRQ 66
> DVB: registering new adapter (FlexCop Digital TV device).
> b2c2-flexcop: reading of MAC address failed.
>
> b2c2-flexcop: i2c master_xfer failed
> b2c2-flexcop: i2c master_xfer failed
> b2c2-flexcop: i2c master_xfer failed
> mt352_read_register: readreg error (reg=127, ret==-121)
> b2c2-flexcop: i2c master_xfer failed
> nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121)
> Unknown/Unsupported NXT chip: 00 00 00 00 00
> b2c2-flexcop: i2c master_xfer failed
> lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret ==  
> -121)
> b2c2-flexcop: i2c master_xfer failed
> b2c2-flexcop: i2c master_xfer failed
> b2c2-flexcop: i2c master_xfer failed
> mt312_read: ret == -121
> b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter
> ACPI: PCI interrupt for device 0000:01:09.0 disabled
>
>
doesn't this card use the stv0299?