[linux-dvb] Artec T1 USB-DVB-T stick with new product ids

[Patrick Boettcher]

Hi Thomas,

On Sun, 26 Mar 2006, Thomas Rabe wrote:
> i have an Artec T1 USB-DVB-T stick. This device have unrecognized product ids 
> tells lsusb,
> in cold state:
> ID 05d8:810b Ultima Electronics Corp.
> in warm state:
> ID 05d8:810c Ultima Electronics Corp.
>
> I have pictures of the stick here:
> http://hal9000.drehmoment.org/artec/artec1.jpg
> http://hal9000.drehmoment.org/artec/artec2.jpg
>
> My first try to get the stick to work was editing  the product ids:
> diff /tmp/linux-2.6.16/drivers/media/dvb/dvb-usb/dvb-usb-ids.h 
> /usr/src/linux/drivers/media/dvb/dvb-usb/dvb-usb-ids.h
> 74,75c74,75
> < #define USB_PID_ULTIMA_TVBOX_USB2_COLD                0x8109
> < #define USB_PID_ULTIMA_TVBOX_USB2_WARM                0x810a
> ---
>> #define USB_PID_ULTIMA_TVBOX_USB2_COLD                0x810b
>> #define USB_PID_ULTIMA_TVBOX_USB2_WARM                0x810c
>
> With this changes the stick loads the firmware successfully, the LED is on. 
> Some devices are created, but the driver create no frontend, dmesg says:
> dvb-usb: no frontend was attached by 'Artec T1 USB2.0'
>
> is there a way to get the stick to work?

It is not so sure, that this stick is based on dib3000 as 
the other ultima-device has been.

Is there any way to open device to see the ICs used?

regards,
Patrick.

--
   Mail: patrick.boettcher at desy.de
   WWW:  http://www.wi-bw.tfh-wildau.de/~pboettch/