[linux-dvb] freecom USB dvb-t -- new vendor/product ID 14aa:022a

Mikel Martin mikel.martin at gmail.com
Mon Mar 27 19:10:56 CEST 2006


Hi Patrick,

  Thanks a lot for your interest. I can't do what you ask yet because I
don't have the dual boot nor the vmware for linux.

  Playing with the dvb-usb-ids.h to force different firmwares to be
downloaded to the stick. I've found the following:

  In windows when I plug the stick it's led blinks for a while (while the
Loader is present) and the the led goes on and stops blinking. (The Receiver
is present now)

  In linux if I force to download the dvb-usb-wt220u-01.fw or
dvb-usb-wt220u-02.fw the sticks's led blinks, but if I force to download any
other the led doesn't switch on. Perhaps this information could help.

  
  Apart from this, which is the mecanism used to choose which driver should
be used? If both modules are installed, zl10353.ko and the
dvb-usb-dtt200u.ko which one would be used?


Regards,

Mikel 
> -----Mensaje original-----
> De: Patrick Boettcher [mailto:patrick.boettcher at desy.de] 
> Enviado el: lunes, 27 de marzo de 2006 14:10
> Para: Mikel Martin
> CC: linux-dvb at linuxtv.org
> Asunto: Re: [linux-dvb] freecom USB dvb-t -- new 
> vendor/product ID 14aa:022a
> 
> Hi Mikel,
> 
> from the logs I can see, that the commands in warm state seem 
> to be equal. 
> So not much to do once, we found the correct firmware.
> 
> To see if it is a different firmware than already used by 
> previous design I have to take a look at the other log-files I have.
> 
> However, can you try the following (will only work with dual-boot):
> 
> Run your PC in Window, let the windows driver download the firmware. 
> Without power off you computer go back to linux and load the 
> driver. If your PC did not reset the USB ports while 
> rebooting, you should get some more results.
> 
> (same could be achieved by running windows in vmware in Linux).
> 
> > When I plug the usb stick, first, the Loader´s "present" 
> present flag 
> > is "yes", and this is the log I get:
> >
> > 
> http://www.zhenit.net/usbsnoopDigital-TV_Loader.loghttp://www.zhenit.n
> > et/usbsnoopDigital-TV_Loader.log
> >
> > In a few seconds the preset flag switches to no an the Receiver 
> > apperas as present.
> >
> > This is the log I get 10Mb during the channel scan:
> >
> > 
> http://www.zhenit.net/usbsnoopDigital-TV_Receiver.loghttp://www.zhenit
> > .net/usbsnoopDigital-TV_Receiver.log
> >
> > In case I could help providing you with any other information, just 
> > ask ;)
> 
> I will create a firmware from the first (loader) log, if 
> necessary, and with it, we will be able to run the device, 
> without booting windows first :).
> 
> regards,
> Patrick.
> 
> --
>    Mail: patrick.boettcher at desy.de
>    WWW:  http://www.wi-bw.tfh-wildau.de/~pboettch/




More information about the linux-dvb mailing list