[linux-dvb] How does my card send diseqc commands ?

[Gregoire Favre]

Hello,

I have tree Hauppauge DVB-s (two FF rev 1.3 and one budget CI).
They are attached to a disecq 1.0 and one of the FF only tune to the
first sat (without) problem while the two others cards can tune to all
sats.

I have tried to exchange the cable : same result.

Does anyone know what could be wrong on my card ?

00:06.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH Siemens/Technotrend/Hauppauge DVB card rev1.3 or rev1.5
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 32 (3750ns min, 9500ns max)
        Interrupt: pin A routed to IRQ 17
        Region 0: Memory at cfffee00 (32-bit, non-prefetchable) [size=512]

00:07.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH Technotrend-Budget/Hauppauge WinTV-NOVA-CI DVB card
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 32 (3750ns min, 9500ns max)
        Interrupt: pin A routed to IRQ 18
        Region 0: Memory at cfffec00 (32-bit, non-prefetchable) [size=512]

00:08.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH Siemens/Technotrend/Hauppauge DVB card rev1.3 or rev1.5
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 32 (3750ns min, 9500ns max)
        Interrupt: pin A routed to IRQ 19
        Region 0: Memory at cfffea00 (32-bit, non-prefetchable) [size=512]

The only difference shown by the first and the second card is :
        Region 0: Memory at cfffee00 (32-bit, non-prefetchable) [size=512]
        Region 0: Memory at cfffea00 (32-bit, non-prefetchable) [size=512]
which surely don't make a difference here...

I would greatly appreciate all suggestions :-)
-- 
Grégoire FAVRE  http://gregoire.favre.googlepages.com  http://www.gnupg.org