[linux-dvb] Artec T1 tuning problems w. 2.6.18

Daniel Kenzelmann linuxtv at kenzelmann.dyndns.info
Tue Sep 26 11:15:52 CEST 2006


Tuning fails with 2.6.18 kernel, firmware gets loaded.

Box is Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs)

works fine with 2.6.17.13


Tuning with tzap gives:
[...]
tuning to 578000000 Hz
video pid 0x0161, audio pid 0x0162
status 00 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
status 04 | signal 0000 | snr 0000 | ber 001fffff | unc 0000ffff | 
[...]

dmesg output:

usb 1-1.3: new full speed USB device using ehci_hcd and address 13
usb 1-1.3: configuration #1 chosen from 1 choice
dvb-usb: found a 'Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs)' in
cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dibusb-an2235-01.fw'
usbcore: registered new driver dvb_usb_dibusb_mb
usb 1-1.1: USB disconnect, address 12
dvb-usb: generic DVB-USB module successfully deinitialized and
disconnected.
usb 1-1.1: new full speed USB device using ehci_hcd and address 14
usb 1-1.1: configuration #1 chosen from 1 choice
dvb-usb: found a 'DiBcom USB1.1 DVB-T reference design (MOD3000)' in
warm state.
dvb-usb: will use the device's hardware PID filter (table count: 16).
DVB: registering new adapter (DiBcom USB1.1 DVB-T reference design
(MOD3000)).
DVB: registering frontend 0 (DiBcom 3000M-B DVB-T)...
dibusb: This device has the Thomson Cable onboard. Which is default.
input: IR-receiver inside an USB DVB receiver as /class/input/input7
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: DiBcom USB1.1 DVB-T reference design (MOD3000) successfully
initialized and connected.







More information about the linux-dvb mailing list