[linux-dvb] DiBcom 3000p tuning failed

Helmut Bardeli helmut.bardeli at gmx.de
Sun Apr 1 22:24:03 CEST 2007


I installed hopefully all necessary drivers and firmware

for a DIBcom 3000p DVB-T device on OpenSuse 10.2 system with 2.6.18
Kernel

dmesg says registered and looks fine for the hardware :

dvb-usb: found a 'DiBcom USB2.0 DVB-T reference design (MOD3000P)' in
cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dibusb-6.0.0.8.fw'
usbcore: registered new driver dvb_usb_dibusb_mc
dvb-usb: generic DVB-USB module successfully deinitialized and
disconnected.
dvb-usb: found a 'DiBcom USB2.0 DVB-T reference design (MOD3000P)' in
warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software
demuxer.
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: DiBcom USB2.0 DVB-T reference design (MOD3000P) successfully
initialized and connected.
saa7146: register extension 'dvb'.


1. dmesg accepts the device including firmware
2. dvb-t works without any problem on XP , therefore no problem with the
antenna.
3. the directory dev/adapter0 ... is there
4. starting kaffeine even notice the BiBcom 3000p
5. dvbscan scans with the result tuning failed 
6. I checked the local channel list de-koeln-bonn , de-ruhrgebiet and
compared it with the
   local definitions , seems to be ok 
7. tzap even don´t give any result , always in status 0000

My triel ends with no result from dvbscan

I use the local definition from de-Ruhrgebiet for 
the channel definition.

Do I have all necessary drivers installed for the Kernel ?
Are there any problems with drivers ?

What can I do to test more ?




More information about the linux-dvb mailing list