[linux-dvb] nova-t 500 usb disconnect

Torgeir Veimo torgeir at pobox.com
Sun Aug 5 23:00:55 CEST 2007


After running with the new firmware and current hg drivers for about  
18 hours, I've got a USB disconnect. Below are excerpts from my log;

Aug  1 18:14:13 htpc2 kernel: MT2060: Spurs after  : f_lo1: 1811000   
f_lo2: 1196700  (kHz)
Aug  1 18:14:13 htpc2 kernel: MT2060: IF1: 1229MHz
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL freq=578166kHz   
f_lo1=1811000kHz  f_lo2=1196700kHz
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL div1=113  num1=12  div2=74   
num2=6502
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 43 71  6 96 95
Aug  1 18:14:13 htpc2 kernel: MT2060: IF1: 1204MHz
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL freq=482000kHz   
f_lo1=1686000kHz  f_lo2=1167850kHz
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL div1=105  num1=24  div2=72   
num2=8115
Aug  1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 56 69  3 fb 91
Aug  1 18:14:14 htpc2 kernel: MT2060: IF1: 1229MHz
Aug  1 18:14:14 htpc2 kernel: MT2060: PLL freq=506000kHz   
f_lo1=1735000kHz  f_lo2=1192850kHz
Aug  1 18:14:14 htpc2 kernel: MT2060: PLL div1=108  num1=28  div2=74   
num2=4531
Aug  1 18:14:14 htpc2 kernel: MT2060: PLL [1..5]: 57 6c  3 1b 95
Aug  1 18:14:14 htpc2 kernel: modifying (0) streaming state for 0
Aug  1 18:14:14 htpc2 kernel: data for streaming: 0 10
Aug  1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug  1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug  1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1
Aug  1 18:14:15 htpc2 kernel: data for streaming: 0 10
Aug  1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug  1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug  1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1
Aug  1 18:14:15 htpc2 kernel: data for streaming: 0 10
Aug  1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1
Aug  1 18:14:15 htpc2 kernel: data for streaming: 10 12
Aug  1 18:14:15 htpc2 kernel: usb 6-1: USB disconnect, address 6
Aug  1 18:14:15 htpc2 kernel: mt2060 I2C write failed
Aug  1 18:14:15 htpc2 kernel: dvb-usb: could not submit URB no. 0 -  
get them all back
Aug  1 18:14:15 htpc2 kernel: modifying (1) streaming state for 0
Aug  1 18:14:15 htpc2 kernel: data for streaming: 10 13
Aug  1 18:14:15 htpc2 kernel: dvb-usb: error while enabling fifo.
Aug  1 18:14:15 htpc2 vdr: [23167] ERROR: can't set filter (pid=18,  
tid=4E, mask=FE): No such device
Aug  1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug  1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug  1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug  1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug  1 18:14:15 htpc2 kernel: ep 0 read error (status = -19)
Aug  1 18:14:15 htpc2 kernel: I2C read failed on address b
Aug  1 18:14:16 htpc2 kernel: ep 0 read error (status = -19)
Aug  1 18:14:16 htpc2 kernel: I2C read failed on address b
Aug  1 18:14:16 htpc2 vdr: [23168] frontend 3 lost lock on channel 1,  
tp 506
Aug  1 18:14:16 htpc2 kernel: ep 0 read error (status = -19)
Aug  1 18:14:16 htpc2 kernel: I2C read failed on address b
Aug  1 18:14:16 htpc2 vdr: [23168] frontend 3 regained lock on  
channel 1, tp 506
Aug  1 18:14:17 htpc2 kernel: ep 0 read error (status = -19)

when loading the firrmware;

Aug  1 00:01:16 htpc2 kernel: dib0700: loaded with support for 3  
different device-types
Aug  1 00:01:16 htpc2 kernel: FW GET_VERSION length: -32
Aug  1 00:01:16 htpc2 kernel: cold: 1
Aug  1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500  
Dual DVB-T' in cold state, will try to load a firmware
Aug  1 00:01:16 htpc2 kernel: b2c2-flexcop: found the stv0299 at i2c  
address: 0x68
Aug  1 00:01:16 htpc2 kernel: DVB: registering frontend 0 (ST STV0299  
DVB-S)...
Aug  1 00:01:16 htpc2 kernel: b2c2-flexcop: initialization of 'Sky2PC/ 
SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
Aug  1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.0[A] ->  
GSI 19 (level, low) -> IRQ 18
Aug  1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002,  
board: Hauppauge Nova-T DVB-T [card=18,autodetected]
Aug  1 00:01:16 htpc2 kernel: TV tuner 4 at 0x1fe, Radio tuner -1 at  
0x1fe
Aug  1 00:01:16 htpc2 kernel: dvb-usb: downloading firmware from file  
'dvb-usb-dib0700-01.fw'
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: Hauppauge model 90002,  
rev C176, serial# 47706
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: MAC address is 00-0D- 
FE-00-BA-5A
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: tuner model is  
Thompson DTT7592 (idx 76, type 4)
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: TV standards ATSC/DVB  
Digital (eeprom 0x80)
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: audio processor is  
None (idx 0)
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: decoder processor is  
CX882 (idx 25)
Aug  1 00:01:16 htpc2 kernel: tveeprom 2-0050: has no radio, has IR  
receiver, has no IR transmitter
Aug  1 00:01:16 htpc2 kernel: cx88[0]: hauppauge eeprom: model=90002
Aug  1 00:01:16 htpc2 kernel: input: cx88 IR (Hauppauge Nova-T DVB-T  
as /class/input/input3
Aug  1 00:01:16 htpc2 kernel: cx88[0]/0: found at 0000:00:08.0, rev:  
5, irq: 18, latency: 32, mmio: 0xea000000
Aug  1 00:01:16 htpc2 kernel: cx88[0]/0: registered device video0 [v4l2]
Aug  1 00:01:16 htpc2 kernel: cx88[0]/0: registered device vbi0
Aug  1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x 8802 Driver Manager
Aug  1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.2[A] ->  
GSI 19 (level, low) -> IRQ 18
Aug  1 00:01:16 htpc2 kernel: cx88[0]/2: found at 0000:00:08.2, rev:  
5, irq: 18, latency: 32, mmio: 0xeb000000
Aug  1 00:01:16 htpc2 kernel: dib0700: firmware started successfully.
Aug  1 00:01:16 htpc2 kernel: cx2388x dvb driver version 0.0.6 loaded
Aug  1 00:01:16 htpc2 kernel: cx8802_register_driver() ->registering  
driver type=dvb access=shared
Aug  1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002,  
board: Hauppauge Nova-T DVB-T [card=18]
Aug  1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x based dvb card
Aug  1 00:01:16 htpc2 kernel: DVB: registering new adapter (cx88[0])
Aug  1 00:01:16 htpc2 kernel: DVB: registering frontend 1 (Conexant  
CX22702 DVB-T)...
Aug  1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500  
Dual DVB-T' in warm state.
Aug  1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2  
transport stream to the software demuxer.
Aug  1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge  
Nova-T 500 Dual DVB-T)
Aug  1 00:01:16 htpc2 kernel: I2C read failed on address b
Aug  1 00:01:16 htpc2 kernel: I2C read failed on address a
Aug  1 00:01:16 htpc2 kernel: DVB: registering frontend 2 (DiBcom  
3000MC/P)...
Aug  1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:11.5[C] ->  
Link [ALKC] -> GSI 22 (level, low) -> IRQ 22
Aug  1 00:01:16 htpc2 kernel: PCI: Setting latency timer of device  
0000:00:11.5 to 64
Aug  1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 =  
1204)
Aug  1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 125
Aug  1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2  
transport stream to the software demuxer.
Aug  1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge  
Nova-T 500 Dual DVB-T)
Aug  1 00:01:16 htpc2 kernel: DVB: registering frontend 3 (DiBcom  
3000MC/P)...
Aug  1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 =  
1229)
Aug  1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 135
Aug  1 00:01:16 htpc2 kernel: dvb-usb: Hauppauge Nova-T 500 Dual DVB- 
T successfully initialized and connected.
Aug  1 00:01:16 htpc2 kernel: usbcore: registered new interface  
driver dvb_usb_dib0700






-- 
Torgeir Veimo
torgeir at pobox.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.linuxtv.org/pipermail/linux-dvb/attachments/20070805/dbde1ca3/attachment.htm 


More information about the linux-dvb mailing list