[linux-dvb] How do you know CAM is recognized ?

[Kristof Pelckmans]

Jeroen Asselman wrote:
> 00:0b.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
>>         Subsystem: Technotrend Systemtechnik GmbH Octal/Technotrend 
>> DVB-C for iTV
>>         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
>> ParErr- Stepping- SERR- FastB2B-
>>         Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
>> <TAbort- <MAbort- >SERR- <PERR-
>>         Latency: 32 (3750ns min, 9500ns max)
>>         Interrupt: pin A routed to IRQ 22
>>         Region 0: Memory at febff400 (32-bit, non-prefetchable) [size=512]
>> <snip>
>> VDR does not mention my CAM :
>>     
>
> I don't see a module budget-av loaded? 
>
> If you do a modprobe budget-av and check your "dmesg" log and perhaps
> you see a:
> "dvb_ca adaptor 0: PC card did not respond :("
>
> If you see that message try to eject and reinsert the cam module after a
> few seconds, perhaps you see a 
> "dvb_ca adapter 0: DVB CAM detected and initialised successfully"
> afterwards in your dmesg.
>   
Jeroen,

Is this budget-av module also required for a Technotrend Premium card ? 
I tried inserting the module, but it doesn't seem to do much...

Kristof