[linux-dvb] ooops ! New DiB0700-firmware

[Nicolas Will]

On Mon, 2007-07-30 at 22:04 +0200, Patrick Boettcher wrote:
> Args, stupid mistake.
> 
> It should be fixed (w/o warranty)! 


Let's see...

get new hg clone
make -j 4 (got to love multiple cores :o) )
sudo make install
sudo reboot

[   31.225984] dvb-usb: found a 'Hauppauge Nova-T 500 Dual DVB-T' in warm state.
[   31.226010] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[   31.226147] DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T)
[   31.311658] DVB: registering frontend 0 (DiBcom 3000MC/P)...
[   31.350445] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 22
[   31.351238] PCI: Setting latency timer of device 0000:00:1b.0 to 64
[   31.353248] MT2060: successfully identified (IF1 = 1220)
[   31.854183] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[   31.854355] DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T)
[   31.857430] DVB: registering frontend 1 (DiBcom 3000MC/P)...
[   31.859432] MT2060: successfully identified (IF1 = 1220)
[   32.355935] input: IR-receiver inside an USB DVB receiver as /class/input/input4
[   32.355959] dvb-usb: schedule remote query interval to 150 msecs.
[   32.355962] dvb-usb: Hauppauge Nova-T 500 Dual DVB-T successfully initialized and connected.
[   32.355985] usbcore: registered new interface driver dvb_usb_dib0700


Time to test MyhtTV !

Be back in a while for initial impressions and remote support.

This http://linuxtv.org/pipermail/linux-dvb/2006-December/014926.html
didn't make it in, apparently.

Is there any way to check which firmware was picked up, or shouldn't I
worry about that? (I have both 01 ans 03-pre1 in the directory)

Nico