[linux-dvb] Problems with Hauppauge HVR 900 (B3C0) hybrid USB

Markus Rechberger mrechberger at gmail.com
Fri Apr 25 07:37:18 CEST 2008


Hi,

On 4/25/08, Joe Ammann <joe at pyx.ch> wrote:
> Hi everybody
>
> I'm trying to get this device (USB 2040:6502) going. I understand that this
> version will probably not give me DVB (only an older release would be
> supported). But at the moment, I can't get anything to work, not even
> analogue or the remote control.
>
> Currently, I'm trying on Fedora 8 with a vanilla 2.6.24.5 kernel and the
> drivers from http://linuxtv.org/hg/v4l-dvb. I also tried with the FC8 stock
> kernel, 2.6.25, the drivers from mcentral.de, and even the userspace drivers
> from Markus Rechberger, following various howto's and instructions.
>
> For most combinations, I can achieve the following:
> - analogue device is recognized and configured (according to
>   dmesg, firmware is loaded, /dev/video0 appears)
> - can't tune anything (with kdetv, device and cable are probably ok, because
>   it works in Windows)
> - IR remote is not recognized (nothing shows up in /proc/bus/input/devices)
>
> With the userspace drivers from mcentral.de on 2.6.25, I got analogue and
> DVB
> recognized and devices installed, but again couldn't tune anything (with
> kdetv and klear).
>
> Before I try to investigate deeper, I thought I'd ask again if my
> expectations
> are right ?!? I *should* be able to get analogue and IR remote working,
> shouldn't I?
>
> I'd be thankful for any hints, pointing me to the most promising
> combination :-) , and willing to post logs and stuff.
>

could you post the dmesg output?

Markus



More information about the linux-dvb mailing list