[linux-dvb] HVR-1600 - mxl5005s - QAM scanning
hermann-pitton at arcor.de
Fri Aug 15 03:43:17 CEST 2008
Am Donnerstag, den 14.08.2008, 21:18 -0400 schrieb Brandon Jenkins:
> On Thu, Aug 14, 2008 at 8:12 PM, Michael Krufky <mkrufky at linuxtv.org> wrote:
> > Brandon Jenkins wrote:
> >> Greetings all,
> >> The last time I tried scanning for QAM it didn't work. If I recall, it
> >> would be a while before the driver could be looked at. Has there been
> >> any change in status worth testing out again?
> > I have an HVR1600 model 74041 -- When I scan for QAM channels, I find the same channels that I find when I scan using any other QAM256-capable device.
> > So yes, it's worth testing again.
> > You wrote that email at noon, and now is eight hours later -- did you test it yet?
> > -Mike
> Actually I did. Unfortunately, no change for usable scans. For me
> there was a change in the scan results when the driver went from
> mxl500x to mxl5005s back in May. (I think it was May) Since then I
> have been using my roof top antenna. However, now that VZ has moved to
> all digitlal channels I would like to see what I actually get via QAM
> I did find 40 services during a scan, but there were no associated
> PIDs. When it functioned, I was getting 80+ services.
> dumping lists (40 services)
> Subsequent scan in SageTV only turned up 1 SD channel.
> During the scan, the following appears in dmesg:
> [52241.432909] DVB: frontend 0 frequency 4294967295 out of range
> [52241.543936] DVB: frontend 0 frequency 4294967295 out of range
> [52254.018384] DVB: frontend 0 frequency 53000000 out of range
> FTR - This was tested on Hauppauge model 74041, rev C5B2
I guess only Ronald Reagan knows the answer.
He had a great speech in Berlin once, about Goethe and east and west ...
Sorry, can't let it ;)
More information about the linux-dvb