[linux-dvb] Satelco EasyWatch + Cryptoworks

Christoph Pfister christophpfister at gmail.com
Sat Feb 2 21:22:22 CET 2008


2008/2/2, David Santinoli <marauder at tiscali.it>:
> On Sat, Feb 02, 2008 at 07:30:30PM +0100, Christoph Pfister wrote:
> > > However, any attempt to access the CAM fails:
> > >
> > >   santinod at romilda:~$ dst_test -c
> > <snip>
> > > Maybe I'm missing something obvious?
> >
> > Yes, those dst_* tools are only needed (and usable) for a few cards.
>
> I see.  Thanks for the tip.
>
> > Try "gnutv" or a normal dvb application (kaffeine, vdr, mythtv, ...).
>
> Actually, I should have mentioned that I had already tried to tune JSTV
> (the encrypted channel I am struggling to watch) without success.
>
> szap gave the following output (a stream could be read from dvr0 but
> apparently was not decrypted, as none of the players I tried could
> decode it):

szap doesn't support descrambling.

> status 1f | signal c6c8 | snr d776 | ber 00000000 | unc 00000000 | FE_HAS_LOCK
>
> while gnutv reported this (and no stream was present at dvr0):

You can run "gnutv -out dvr" or "gnutv -out file <filename>".

> status S     | signal bb77 | snr 8feb | ber 0000ff08 | unc 00000000 |
>
>
> On the other side, "gnutv -cammenu" at least caused the CAM to give some
> sign of life:
>
> santinod at romilda:~$ gnutv -cammenu
> CAM Application type: 01
> CAM Application manufacturer: d000
> CAM Manufacturer code: 0000
> CAM Menu string: CryptoWorks
> CAM supports the following ca system ids:
>   0x0d01
> ------------------------------
> Main menu of CryptoWorks CI module
> Please select an item
> 0. Quit menu
> 1. General Smartcard information
> 2. Available entitlements
> 3. Smart card management
> 4. Language
> 5. Check for new software
> CryptoWorks V4.00.008
> Enter option:
>
> (all menu options appear to work - i.e. cause some other sumbenus to be
> displayed - but no listed option seems useful.)
>
> I'm a bit puzzled...
>
> Cheers,
>  David
>

Christoph



More information about the linux-dvb mailing list