[linux-dvb] wintv-hvr-1250 setup?

[Henry Leinhos]

Hi, 

I recently acquired a Hauppauge wintv-hvr-1250 PCIe ATSC tuner card and have 
compiled/installed the latest v4l-dvb drivers ok. 

(BTW, I'm using an ABIT AN-M2HD motherboard with an AMD 4000+ cpu) 

I'm not sure which modules are required, but when I load the cx23885 module 
(via /sbin/modprobe cx23885), I get an error on the tveeprom header.  dmesg 
reports: 

CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 
[card=3,autodetected]
cx23885[0]: i2c bus 0 registered
cx23885[0]: i2c bus 1 registered
cx23885[0]: i2c bus 2 registered
tveeprom 4-0050: Encountered bad packet header [ff]. Corrupt or not a 
Hauppauge eeprom.
cx23885[0]: warning: unknown hauppauge model #0
cx23885[0]: hauppauge eeprom: model=0
cx23885[0]: cx23885 based dvb card
MT2131: successfully identified at address 0x61
DVB: registering new adapter (cx23885[0])
DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)...
cx23885_dev_checkrevision() Hardware revision = 0xb0
cx23885[0]/0: found at 0000:03:00.0, rev: 2, irq: 16, latency: 0, mmio: 
0xfce00000
PCI: Setting latency timer of device 0000:03:00.0 to 64 


I'm concerned about the tveeprom message  -- are there any other modules I 
need to load for this board?  Is there any firmware I'm missing? 

Thanks,
Henry