[linux-dvb] Pinnacle PCTV Dual DVB-T Diversity Stick built in IR-Receiver supported ?

[Ingo Arndt]

Hello,

as I haven't received any answer yet I'll post my question again,

I have a Pinnacle PCTV Dual DVB-T Diversity Stick which works fine.
The only thing I am missing is the built-in infrared receiver which is not recognized.

Is anyone using this Pinnacle DVB-T stick and got it's remote control working ?

Am I missing a module, a module option or something else 
or is the ir receiver just not supported by now ?

I use the kernel 2.6.25 with tuxonice-patches on archlinux.

lsusb output:
------------------------- lsusb output start ---
idVendor           0x2304 Pinnacle Systems, Inc. [hex]
  idProduct          0x0229 
  bcdDevice            0.01
  iManufacturer           1 PINNACLE
  iProduct                2 PCTV 2001e
  iSerial                 3 12027630
------------------------- lsusb output stop ---


mesg output:
---------------- dmesg code start ---
usb 7-3: new high speed USB device using ehci_hcd and address 9
usb 7-3: configuration #1 chosen from 1 choice
dvb-usb: found a 'Pinnacle PCTV Dual DVB-T Diversity Stick' in cold state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.10.fw'
dib0700: firmware started successfully.
dvb-usb: found a 'Pinnacle PCTV Dual DVB-T Diversity Stick' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Pinnacle PCTV Dual DVB-T Diversity Stick)
DVB: registering frontend 0 (DiBcom 7000PC)...
DiB0070: successfully identified
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Pinnacle PCTV Dual DVB-T Diversity Stick)
DVB: registering frontend 1 (DiBcom 7000PC)...
DiB0070: successfully identified
dvb-usb: Pinnacle PCTV Dual DVB-T Diversity Stick successfully
initialized and connected.
----------------- dmesg code end ---


Best regards,
 Ingo