[linux-dvb] Technisat DVB-C - "b2c2-flexcop: no frontend driver found for this"

[Nando Hiller]

Hi,
since changeset 7469 the frontend driver of my technisat can't be loaded.
Have someone a solution of this problem?

test:
hg clone http://linuxtv.org/hg/v4l-dvb
hg update 7469 
make && make install
modprobe b2c2-flexcop-pci 

tail -f /log/messages
...
Jun  7 22:43:15 [kernel] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV 
receiver chip loaded successfully
Jun  7 22:43:15 [kernel] flexcop-pci: will use the HW PID filter.
Jun  7 22:43:15 [kernel] flexcop-pci: card revision 2
Jun  7 22:43:15 [kernel] ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [LNK2] -> 
GSI 5 (level, low) -> IRQ 5
Jun  7 22:43:15 [kernel] DVB: registering new adapter (FlexCop Digital TV 
device)
Jun  7 22:43:15 [kernel] b2c2-flexcop: MAC address = 00:d0:d7:08:0d:7f
Jun  7 22:43:15 [kernel] b2c2-flexcop: i2c master_xfer failed
                - Last output repeated 2 times -
Jun  7 22:43:16 [kernel] mt352_read_register: readreg error (reg=127, 
ret==-121)
Jun  7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed
Jun  7 22:43:16 [kernel] nxt200x: nxt200x_readbytes: i2c read error (addr 
0x0a, err == -121)
Jun  7 22:43:16 [kernel] Unknown/Unsupported NXT chip: 00 00 00 00 00
Jun  7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed
Jun  7 22:43:16 [kernel] lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 
error (ret == -121)
Jun  7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed
                - Last output repeated twice -
Jun  7 22:43:16 [kernel] stv0297_readreg: readreg error (reg == 0x80, ret 
== -121)
Jun  7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed
Jun  7 22:43:16 [kernel] mt312_read: ret == -121
Jun  7 22:43:16 [kernel] b2c2-flexcop: no frontend driver found for this 
B2C2/FlexCop adapter
...

bye,
Nando