[linux-dvb] Any chance of help with v4l-dvb-experimental / Avermedia A16D please?
timf
timf at iinet.net.au
Sat Mar 15 10:33:56 CET 2008
Hi Mauro,
On Fri, 2008-03-14 at 17:21 -0300, Mauro Carvalho Chehab wrote:
> On Sat, 15 Mar 2008 04:34:34 +0900
> timf <timf at iinet.net.au> wrote:
>
>
> > > Now, do two tests, with v4l-dvb tree + the patch:
>
> Of course, you'll need to compile and install v4l-dvb ;)
> make
> make install
>
> > cx88-dvb or saa7134-dvb ?
> saa7134-dvb.
>
>
> Cheers,
> Mauro
This time:
1) new install of ubuntu 7.10
2) mercurial v4l-dvb, patched
3) make, sudo make install
4) in /etc/modprobe.d/options
timf at ubuntu:~$ sudo cat /etc/modprobe.d/options
[sudo] password for timf:
# Enable double-buffering so gstreamer et. al. work
options quickcam compatible=2
# Default hostap to managed mode
options hostap_pci iw_mode=2
options hostap_cs iw_mode=2
options tuner-xc2028 debug=1
options tuner debug=1
options saa7134 tuner=71 i2c_scan=1
timf at ubuntu:~$
5) xc3028-v27.fw into /lib/firmware/2.6.22-14-generic
sudo chmod 644 xc3028-v27.fw
6) reboot
7) dmesg
<snip>
[ 14.856000] ACPI: PCI Interrupt 0000:00:05.0[A] -> Link [APC7] -> GSI
16 (level, low) -> IRQ 20
[ 14.856000] PCI: Setting latency timer of device 0000:00:05.0 to 64
[ 14.860000] NVRM: loading NVIDIA UNIX x86 Kernel Module 100.14.19
Wed Sep 12 14:12:24 PDT 2007
[ 14.860000] parport_pc 00:08: reported by Plug and Play ACPI
[ 14.860000] parport0: PC-style at 0x378 (0x778), irq 7, dma 3
[PCSPP,TRISTATE,COMPAT,ECP,DMA]
[ 14.936000] Linux video capture interface: v2.00
[ 14.952000] usbcore: registered new interface driver xpad
[
14.952000] /build/buildd/linux-source-2.6.22-2.6.22/drivers/input/joystick/xpad.c: driver for Xbox controllers v0.1.6
[ 14.996000] saa7130/34: v4l2 driver version 0.2.14 loaded
[ 15.000000] ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
[ 15.000000] ACPI: PCI Interrupt 0000:04:09.0[A] -> Link [APC2] -> GSI
17 (level, low) -> IRQ 21
[ 15.000000] saa7133[0]: found at 0000:04:09.0, rev: 209, irq: 21,
latency: 32, mmio: 0xfdbff000
[ 15.000000] saa7133[0]: subsystem: 1461:f936, board: AVerMedia Hybrid
TV/Radio (A16D) [card=137,autodetected]
[ 15.000000] saa7133[0]: board init: gpio is 2fa00
[ 15.168000] saa7133[0]: i2c eeprom 00: 61 14 36 f9 00 00 00 00 00 00
00 00 00 00 00 00
[ 15.168000] saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 01 00 08 ff
00 0e ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 40: ff 65 00 ff c2 1e ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.168000] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff
[ 15.184000] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom]
[ 15.196000] saa7133[0]: i2c scan: found device @ 0xc2 [???]
[ 15.296000] tuner' 2-0061: Setting mode_mask to 0x0e
[ 15.296000] tuner' 2-0061: chip found @ 0xc2 (saa7133[0])
[ 15.296000] tuner' 2-0061: tuner 0x61: Tuner type absent
[ 15.304000] tuner' 2-0061: switching to v4l2
[ 15.304000] tuner' 2-0061: tv freq set to 400.00
[ 15.304000] tuner' 2-0061: tuner type not set
[ 15.304000] tuner' 2-0061: tv freq set to 400.00
[ 15.304000] tuner' 2-0061: tuner type not set
[ 15.304000] saa7133[0]: registered device video0 [v4l2]
[ 15.304000] saa7133[0]: registered device vbi0
[ 15.304000] saa7133[0]: registered device radio0
[ 15.304000] tuner' 2-0061: Cmd TUNER_SET_STANDBY accepted for analog
TV
[ 15.332000] saa7134 ALSA driver for DMA sound loaded
[ 15.332000] saa7133[0]/alsa: saa7133[0] at 0xfdbff000 irq 21
registered as card -2
[ 15.392000] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22
[ 15.392000] ACPI: PCI Interrupt 0000:00:10.1[B] -> Link [AAZA] -> GSI
22 (level, low) -> IRQ 17
[ 15.392000] PCI: Setting latency timer of device 0000:00:10.1 to 64
<snip>
7) lsmod
<snip>
loop 19076 0
snd_hda_intel 263712 1
saa7134_alsa 15648 0
snd_pcm_oss 44672 0
snd_mixer_oss 17664 1 snd_pcm_oss
tuner 27724 0
tea5767 8324 1 tuner
tda8290 14340 1 tuner
tda18271 31880 1 tda8290
tda827x 11396 1 tda8290
tuner_xc2028 22288 1 tuner
xc5000 11396 1 tuner
tda9887 12036 1 tuner
tuner_simple 14092 1 tuner
tuner_types 14976 1 tuner_simple
mt20xx 13704 1 tuner
tea5761 6276 1 tuner
snd_pcm 80388 3 snd_hda_intel,saa7134_alsa,snd_pcm_oss
snd_seq_dummy 4740 0
snd_seq_oss 33152 0
snd_seq_midi 9600 0
snd_rawmidi 25728 1 snd_seq_midi
snd_seq_midi_event 8448 2 snd_seq_oss,snd_seq_midi
snd_seq 53232 6
snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_seq_midi_event
snd_timer 24324 2 snd_pcm,snd_seq
snd_seq_device 9228 5
snd_seq_dummy,snd_seq_oss,snd_seq_midi,snd_rawmidi,snd_seq
saa7134 142676 1 saa7134_alsa
snd 54660 12
snd_hda_intel,saa7134_alsa,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_seq_oss,snd_rawmidi,snd_seq,snd_timer,snd_seq_device
xpad 9988 0
videodev 34432 2 tuner,saa7134
v4l1_compat 16004 1 videodev
compat_ioctl32 2304 1 saa7134
v4l2_common 12672 2 tuner,saa7134
videobuf_dma_sg 14724 2 saa7134_alsa,saa7134
videobuf_core 19460 2 saa7134,videobuf_dma_sg
ir_kbd_i2c 11280 1 saa7134
soundcore 8800 1 snd
ir_common 38404 2 saa7134,ir_kbd_i2c
parport_pc 37412 1
nvidia 6221648 34
snd_page_alloc 11400 2 snd_hda_intel,snd_pcm
psmouse 39952 0
serio_raw 8068 0
tveeprom 13572 1 saa7134
i2c_nforce2 7040 0
parport 37448 3 ppdev,lp,parport_pc
pcspkr 4224 0
agpgart 35016 1 nvidia
k8temp 6656 0
i2c_core 26112 17
tuner,tea5767,tda8290,tda18271,tda827x,tuner_xc2028,xc5000,tda9887,tuner_simple,mt20xx,tea5761,saa7134,v4l2_common,ir_kbd_i2c,nvidia,tveeprom,i2c_nforce2
shpchp 34580 0
pci_hotplug 32704 1 shpchp
evdev 11136 4
<snip>
8) The chip on my card is xc3018. Why does module xc5000 load?
Regards,
Tim
More information about the linux-dvb
mailing list