[linux-dvb] DVB-S Channel searching problem
Roman Jarosz
roman.jarosz at gmail.com
Sat Jan 3 17:42:38 CET 2009
Hi,
I have a problem with DVB-S channel searching, the scan command doesn't find all channels in Linux on Astra 19.2E.
It works in Windows.
For instance the scan doesn't find RTL2, but if I add to channels.conf
RTL2:12187:h:0:27500:166:128:12020
then szap -r works correctly.
I have TeVii S460 DVB-S/S2.
Linux kernel 2.6.28.
Can anybody help me to find out why the scan doesn't work correctly.
I've compiled kernel from source so I can apply patches or change its settings.
Regards,
Roman
lspci:
00:09.0 Multimedia video controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder (rev 05)
Subsystem: Unknown device d460:9022
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at e8000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
00:09.2 Multimedia controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder [MPEG Port] (rev 05)
Subsystem: Unknown device d460:9022
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at e9000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [4c] Power Management version 2
This is part of dmesg:
cx8800 0000:00:09.0: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
cx88[0]: quirk: PCIPCI_NATOMA -- set TBFX
cx88[0]: subsystem: d460:9022, board: TeVii S460 DVB-S/S2 [card=70,autodetected], frontend(s): 1
cx88[0]: TV tuner type -1, Radio tuner type -1
cx88[0]/0: found at 0000:00:09.0, rev: 5, irq: 10, latency: 32, mmio: 0xe8000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
Linux agpgart interface v0.103
agpgart-intel 0000:00:00.0: Intel 440BX Chipset
agpgart-intel 0000:00:00.0: AGP aperture is 32M @ 0xe4000000
EXT3 FS on sda1, internal journal
Adding 1020088k swap on /dev/sda5. Priority:-1 extents:1 across:1020088k
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda6, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
loop: module loaded
eth2: link up, 100Mbps, full-duplex, lpa 0xC5E1
warning: `proftpd' uses 32-bit capabilities (legacy support in use)
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
cx88[0]/2: cx2388x 8802 Driver Manager
cx88-mpeg driver manager 0000:00:09.2: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
cx88[0]/2: found at 0000:00:09.2, rev: 5, irq: 10, latency: 32, mmio: 0xe9000000
cx8802_probe() allocating 1 frontend(s)
cx88/2: cx2388x dvb driver version 0.0.6 loaded
cx88/2: registering cx8802 driver, type: dvb access: shared
cx88[0]/2: subsystem: d460:9022, board: TeVii S460 DVB-S/S2 [card=70]
cx88[0]/2: cx2388x based DVB/ATSC card
DVB: registering new adapter (cx88[0])
DVB: registering adapter 0 frontend 0 (Conexant CX24116/CX24118)...
cx24116_firmware_ondemand: Waiting for firmware upload (dvb-fe-cx24116.fw)...
i2c-adapter i2c-0: firmware: requesting dvb-fe-cx24116.fw
cx24116_firmware_ondemand: Waiting for firmware upload(2)...
cx24116_load_firmware: FW version 1.23.86.1
cx24116_firmware_ondemand: Firmware upload complete
More information about the linux-dvb
mailing list