[vdr] Xineliboutput segmentation fault
kimmo.taskinen at dnainternet.net
Thu May 8 16:48:18 CEST 2008
This probably isn't anyhow related to this thread but I get following
messages in dmesg output:
vdr-fbfe: segfault at 000004d0 eip b7207719 esp bfd4c9e0 error 4
vdr-fbfe: segfault at 000004d0 eip b720a719 esp bfcfa190 error 4
It's not a big problem as it's only related to exiting the frontend
either with keyboard ESC or killall vdr-sxfe.
It's the yesterday's cvs version. I can't say when did it start.
On 08 May 2008, at 11:07, Petri Helin wrote:
> Graziano Pavone wrote:
>> 2008/5/7 Petri Helin <phelin at googlemail.com <mailto:phelin at googlemail.com
>> Could you update xineliboutput from the cvs and try again? In
>> case you
>> still see the same behaviour, attach your setup.conf (or just the
>> xineliboutput subset) and ~/.xine/config_xineliboutput and tell
>> exact command you use to start vdr-sxfe.
>> For your information, I use vdr-sxfe with the current cvs and I
>> experience any problems with cropping.
>> I will try with the CVS version, anyway I don't think it's
>> fault, since it's working on the main PC (also with crop enabled).
>> I suspect it's some dependencies missing on the client...
> The obvious one to check is that you have the autocrop post plugin in
> place: ls `xine-config --plugindir`/post/xineplug_post_autocrop.so
> You could start vdr-sxfe with argument "--verbose" and see if there
> any complaints in the output.
> vdr mailing list
> vdr at linuxtv.org
More information about the vdr