Technisat CableStar HD2: Difference between revisions

From LinuxTVWiki
Jump to navigation Jump to search
Line 22: Line 22:
===Installation===
===Installation===


Download and install the latest mantis drivers like this:
You need support for I²C in your Kernel for this card to work. Download the necessary mantis-modules from [http://jusst.de/hg/mantis Jusst.de] or use Mercurial:

hg clone http://mercurial.intuxication.org/hg/s2-liplianin
cd s2-liplianin
make
sudo make install
sudo reboot

Old mantis repository instructions: You need support for I²C in your Kernel for this card to work (that's normal). Download the necessary mantis-modules from [http://jusst.de/hg/mantis Jusst.de] or use Mercurial:


$ hg clone http://jusst.de/hg/mantis
$ hg clone http://jusst.de/hg/mantis
Line 29: Line 37:
$ make install
$ make install


If everything went well, you need to load the following modules:
If everything went well, the following modules will load:


dvb-core
dvb-core

Revision as of 13:04, 7 January 2009

Overview

Seems to be based on the Twinhan (former Azureweave) AD-CP400 (VP-2040) Uses the Philips TDA10021 Demodulator, Phillips CU1216 Tuner and Digimove Mantis bridge chip.


Identification

 $ lspci -vv -s 05:01.0
   05:01.0 Multimedia controller: Twinhan Technology Co. Ltd Mantis DTV PCI Bridge Controller [Ver 1.0] (rev 01)
   Subsystem: Device 1ae4:0002
   Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
   Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
   Latency: 64 (2000ns min, 63750ns max)
   Interrupt: pin A routed to IRQ 10
   Region 0: Memory at f8fff000 (32-bit, prefetchable) [size=4K]
 $ lspci -n -s 05:01.0
   05:01.0 0480: 1822:4e35 (rev 01)

Installation

Download and install the latest mantis drivers like this:

hg clone http://mercurial.intuxication.org/hg/s2-liplianin
cd s2-liplianin
make
sudo make install
sudo reboot

Old mantis repository instructions: You need support for I²C in your Kernel for this card to work (that's normal). Download the necessary mantis-modules from Jusst.de or use Mercurial:

 $ hg clone http://jusst.de/hg/mantis
 $ cd mantis
 $ make
 $ make install

If everything went well, the following modules will load:

 dvb-core
 tda10021
 cu1216
 mantis
 b2c2-flexcop-pci

Troubleshooting

I had problems compiling all of the modules in the current mantis package from [1] but i could solve them by doing a make menuconfig and deselecting most modules except those i really needed (see above)