[linux-dvb] Re: Cinergy 1200 DVB-T TDA10046H / auto mode causes problems

[Andrew de Quincey <adq_dvb@lidskialf.net>]

On Friday 19 Nov 2004 22:46, Robert Schlabbach wrote:
> From: "Andrew de Quincey" <adq_dvb@lidskialf.net>
>
> > It keeps going until it locks. But the thing is - it DOES lock very
> > quickly - just that the data is very corrupt. The interesting thing
> > is that the BER is always 0 post-lock.... assuming the BER measurement
> > is OK, that means the data must be being lost after the demodulator
>
> stage.
>
> You mean corrupt in a way other than the transport error bit being set in
> the MPEG-2 transport packet header? Maybe the transport stream interface is
> behaving "weird" in this state? Then you might want to look at the
> registers Conf_TS1 and Conf_TS2 (0x1E and 0x1F) and try e.g. output Mode A
> and output Mode B and see if one of those doesn't have this problem...

I'll give it a go - what I actually mean is lots of missing data - I have not 
tested to see if the contents of the packets I do receive themselves are 
corrupt.