[linux-dvb] DISEQC setting on Skystar1 failed

[Vedran Rodic <vedran@vodatel.hr>]

Hello

I have a Skystar1 rev 1.0 card.

The problem is that DISEQC setting doesn't work. 

I have a skystar2 card on the same setup and it works fine.

I'm using this line to tune:


# dvbtune -c 0 -D B  -f 11475000 -p V -s 27500 -m
Using DVB card "DST DVB-S"
tuning DVB-S to Freq: 1725000, Pol:V Srate=27500000, 22kHz tone=off, LNB: 66
SETTING SIMPLE B BURST
DISEQC SETTING FAILED

The driver is the latest CVS. Should I test some other version?


This is the dmesg debug output when initializing the driver:

Linux video capture interface: v1.00
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI interrupt 0000:02:07.0[A] -> GSI 19 (level, low) -> IRQ 19
bttv0: Bt878 (rev 17) at 0000:02:07.0, irq: 19, latency: 32, mmio:
0xdd000000
bttv0: detected: Twinhan VisionPlus DVB-T [card=113], PCI subsystem ID
is 1822:0001
bttv0: using: Twinhan DST + clones [card=113,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00f58afd [init]
bttv0: using tuner=4
tuner: Ignoring new-style parameters in presence of obsolete ones
bttv0: add subdevice "dvb0"
bt878: AUDIO driver version 0.0.0 loaded
bt878: Bt878 AUDIO function found (0).
ACPI: PCI interrupt 0000:02:07.1[A] -> GSI 19 (level, low) -> IRQ 19
bt878(0): Bt878 (rev 17) at 02:07.1, irq: 19, latency: 32, memory:
0xdd001000
DVB: registering new adapter (bttv0).
dst_check_ci: recognize DSTMCI
DST type : satellite
DST type flags : 0x1 newtuner
DVB: registering frontend 0 (DST DVB-S)...

lcpci command lists these PCI devices:
0000:02:07.0 Multimedia video controller: Brooktree Corporation Bt878
Video Capture (rev 11)
0000:02:07.1 Multimedia controller: Brooktree Corporation Bt878 Audio
Capture (rev 11)



Thank you

Vedran Rodic