[vdr] Re: 1.1.13 - simple diseqc question

["Rene Bartsch" <vdr@bartschnet.de>]

----- Original Message -----
From: "Dariush Forouher" <dariush@forouher.de>
To: <vdr@linuxtv.org>
Sent: Saturday, October 26, 2002 9:12 PM
Subject: [vdr] Re: 1.1.13 - simple diseqc question


> Am Sam, 2002-10-26 um 19.14 schrieb Rene Bartsch:
> > As your switch can handle diseqc, you should remove the tone/voltage
> > commands for faster switching.
> >
> > S19.2E  11700 V  9750  W5 [E0 10 38 F0]
> > S19.2E  99999 V 10600 W5 [E0 10 38 F1]
> > S19.2E  11700 H  9750  W5 [E0 10 38 F2]
> > S19.2E  99999 H 10600 W5 [E0 10 38 F3]
> >
> > S13E    11700 V  9750  W5 [E0 10 38 F4]
> > S13E    99999 V 10600 W5 [E0 10 38 F5]
> > S13E    11700 H  9750  W5 [E0 10 38 F6]
> > S13E    99999 H 10600 W5 [E0 10 38 F7]
> >
> > You have to try the wait-time Wnnn. Values below 5 were to fast for
> > syncronizing at my setup and every higher value slows down switching.
> > Eventually you have to exchange the F-values between the satelites. In
this
> > configuration Astra is the first LNB (F0 - F3) and Hotbird the second
> > (F4-F7).
> That doesn't work with my switch. This is the easiest working config
> I've fount:
> S19.2E  11700 V  9750 t v # 1st LNB
> S19.2E  99999 V 10600 T v
> S19.2E  11700 H  9750 t V
> S19.2E  99999 H 10600 T V
> S13E    11700 V  9750 t v [E0 10 38 F4] t #2nd LNB
> S13E    99999 V 10600 t v [E0 10 38 F4] T
> S13E    11700 H  9750 t V [E0 10 38 F4] t
> S13E    99999 H 10600 t V [E0 10 38 F4] T
>
> In the "manual" of the switch is written, that it only supports diseqc
> 1.0. Could this be the reason?
>

No, the above Hex-commands are diseqc 1.0.
You're only using 22khz/13V/18V at ASTRA to switch (very slow ...)

I assume you're running a 9/x-multiswitch with two quaddro-LNBs, first
directed to ASTRA and the second to HOTBIRD?

Rene



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.