[vdr] Re: Nova-t UK

[David Lusty <dlusty@ntlworld.com>]

./dvbtune -f 489833000 -i
Using DVB card "Grundig 29504-401"
tuning DVB-T (in United Kingdom) to 489833000 Hz
polling....
Getting frontend event
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI
FE_HAS_SYNC
Bit error rate: 184
Signal strength: 14135
SNR: 58853
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI
FE_HAS_SYNC
<transponder type="T" freq="489833000">
Nothing to read from fd_sdt
</transponder>


I did get xml output from the command earlier, not sure what I did to
break it, but it's obvious this is a driver issue again. when I ran this
last time it gave me a list of 4 channels






On Wed, 2003-05-14 at 00:22, Gavin Hamill wrote:
> On Wed, May 14, 2003 at 12:15:51AM +0100, David Lusty wrote:
> > ok now I get the following, any ideas? as you can see I replaced the
> > frequency with the one for Rowridge I got from scanning, is this
> > correct? thanks for your help :o)
> > 
> >  ./dvbstream -f 489833330 -ps -o 600 601 | mplayer - -nocache
> 
> > Getting frontend event
> > FE_STATUS: FE_HAS_SIGNAL FE_TIMEDOUT
> > Not able to lock to the signal on the given frequency
> 
> These are the only important lines, and the error speaks for itself :)
> 
> Can you try 'dvbtune -f 489833330 -i' and tell me if you get the XML 
> output? Or 'dvbtune -m' and paste a few lines of the output?
> 
> Cheers,
> Gavin.
> 
> 



-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.