[vdr] Re: Hauppauge Remote-control and CAM dislike each other

[Wolfgang Goeller <wgoeller@heraklit.ch>]

Oliver Endriss wrote:

> Hm, the only place where it might interfere is on the ARM side. :-(
> - Unless you press a key on the remote transmitter, there is no data
>   transfer from the ARM to the driver. 
> - The remote plugin does blocking reads, so there is virtually no cpu
>   load caused by this plugin.
>
> Maybe the infred receiver receives noise and keeps the ARM busy(?)
> Do the messages stop when you remove the IR receiver or cover the 
> receiver with tape?
Sorry - since I switched to Viaccess Ver 1.0 all this problems
disappeared - I can't reproduce it. On the other hand I do have rather
much IR-noise - e.g. from the IRC_serial remote :-)

But even that doesnt't disturb the Viaccess Ver 1.0 a lot.
Only channel-switching with the Hauppauge remote control seems
to be a bit slower compared to IRC_serial.

My solution was very simple: I have one serial-Switch and both
computers share now the LIRC_serial device. It's more convenient
because of the higher number of keys. :-)

regards
Wolfgang



--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.