KNC One TV-Station DVR

Card features

• PCI interface
• SAA7134 chipset
• RDS-Tuner Chip SAA6588 chopset
• MPEG-Decoder Chip SAA6752HS
• FM, TV, Composite, S-Video and Audio inputs (outside)
• Two conectors (one is Audio out) (inside)

How to make it work

It was detected automaticly as card=24.

The sound dosn't work from internal Mixer (in the moment - should work according to Video4Linux Mailing List). I solve it in the moment, that I use the Audio-out conector inside. If you hold the slot-metall at left and the PCI-conector on the lower side, the Audio-Out conector is on the lower one. The 4 pins from the white MIDI-conector are from left side: left-chanel / ground / right-chanel / ground. This one I conect with one Audio-Input (Aux) on my sound card (SoundBlaster Live! 5.1). If I switch the input to this chanel, the sound works fine.

The MPEG-Decoder dosn't work (in the moment - should work according to Video4Linux Mailing List).

Kernel

The card runs on Kernel 2.6.11.4 (SuSE 9.3).

Not all features suported in the moment. Working in process.

Cuting from my message-log:

saa7130/34: v4l2 driver version 0.2.12 loaded
ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 19 (level, low) -> IRQ 209
saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 209, latency: 64, mmio: 0xf6000000
saa7134[0]: subsystem: 1894:a006, board: KNC One TV-Station DVR [card=24,autodetected]
saa7134[0]: board init: gpio is 830000
saa7134[0]: i2c eeprom 00: 94 18 06 a0 06 80 00 01 00 00 00 00 00 00 01 00
saa7134[0]: i2c eeprom 10: 00 ff 86 0e ff 20 ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: 01 40 01 02 02 03 01 03 06 ff 01 df ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner: chip found at addr 0xc0 i2c-bus saa7134[0]
tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by saa7134[0]
tda9885/6/7: chip found @ 0x86
saa6752hs: chip found @ 0x40
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]: registered device radio0
saa7134[0]/audio: audio carrier scan failed, using 5.500 MHz [default]
saa7134[0]/irq[10,4294915314]: r=0x20 s=0x00 PE
saa7134[0]/irq: looping -- clearing PE (parity error!) enable bit

Viewers

kdetv

kRadio (dosn't work in the moment - see above)

Teletext

kdetv

See also

bttv (and more) tv,video and radio card gallery

Linux runing Hardware chapter PCI-Karten (German)