Talk:Dvbscan

From LinuxTVWiki
Revision as of 11:27, 29 March 2007 by Helmut (talk | contribs)
Jump to navigation Jump to search

BIBcom 3000p tuning failed I installed hopefully all necessary drivers and firmware for a DIBcom 3000p DVB-T device on OpenSuse 10.2 system with 2.6.18 Kernel

dmesg says registered and looks fine for the hardware.

My triel ends with no result from dvbscan

I use the local definition from de-Ruhrgebiet for the channel definition.

Do I have all necessary drivers installed for the Kernel ? What can I do to test more ?

regards, Helmut

CityK 04:12, 29 March 2007 (CEST)
Was there any message about the device's firmware being loaded in dmesg?
If that isn't the problem, then my other quick thought is that you have an issue with reception via the antenna.
Anyway, you should subscribe to the dvb mailing list, or the #linuxtv irc channel and describe your problem -- you will get much
better support there. The wiki sees low traffic and/or use, as well as being not particularly appropriate as a forum for user troubleshooting
(whereas the m/l or irc channel are ideal).

Thanks for quick info. I will join the dvb mailing list #linuxtv irc channel

The problem is that everything looks ok.

1. dmesg accepts the device including firmware 2. dvb-t works without any problem on XP , therefore no problem with the antenna. 3. the directory dev/adapter0 ... is there 4. starting kaffeine even notice the BiBcom 3000p 5. dvbscan scans with the result tuning failed 6. I checked the local channel list de-koeln-bonn , de-ruhrgebiet and compared it with the

  local definitions , seems to be ok 

7. tzap even don´t give any result , always in status 0000