[vdr] Re: SV: CAM support, was Improved CAM support in VDR

[micael.beronius@telia.com]

Hi again,

I have done some further testing. It is the line
"if (poll(pfd, 1, 3500/*XXX*/) && (pfd[0].revents & POLLIN))"
in int cCiTransportConnection::RecvTPDU(void), that time outs.

I have tried 10500 and it still time outs.

I will investigate more, just wanted to post some interims...

 - Micael

mbtc> Hello Klaus,

mbtc> Also I get no response. (only --> 00 01 82 01 01)

mbtc> I am using a viaccess redline CAM, which works somewhat using the
mbtc> old "built in" CI/CAM firmware. (Driver reloads are necessary most of
mbtc> the time to get it working). I'm very optimistic about this CAM issue
mbtc> being dealt with by vdr, since in reality vdr is not usable for me
mbtc> with the current built in CAM stuff.

mbtc> Kernel 2.4.19
mbtc> DVB-C 2.1
mbtc> CI 3.5"(floppy) model Rev. 1.6          <- Could this be the common problem?
mbtc> linux-dvb.2003-01-08-ci-ll driver
mbtc> vdr-1.1.21 + latest ci.c

mbtc> I have tried the CAM in both slots, reload the driver, restarting vdr.


mbtc> What can I do to help?

mbtc> regards
mbtc>  Micael

mbtc> Saturday, January 11, 2003, 5:22:36 PM, you wrote:

KS>> Tomas Prybil wrote:
>>> 
>>> First of all Klaus thanks again for your tremendous effort regarding the VDR
>>> software!!
>>> 
>>> My vdr installation has been sleeping for quite some time because of the CAM
>>> problems. Here in Scandinavia almost all channels are encrypted and now I
>>> really look forward to use my vdr again!
>>> 
>>> However my installation doesn't really work.
>>> 
>>> Currently I have the following config:
>>> Kernel 2.4.10
>>> Technotrend DVB-S Rev 1.5
>>> CAM card "holder" Rev 1.6
>>> linux-dvb.2003-01-08-ci-ll driver
>>> vdr-1.1.21
>>> 
>>> The setup doesn't detect my CAM modules. I've tested both the Conax and
>>> Viacess but the only thing I get is the initial handshake --> 00 01 82 01 01
>>> but no response :( Normally they work in my Nokia box.
>>> 
>>> Any ideas?

KS>> Are you sure you have installed the CAM in the "0" slot?
KS>> Try both slots. Since there is no response to the [00 01 82 01 01] there
KS>> is nothing VDR can do. So I would assume that the CAM is in the wrong
KS>> slot.

KS>> Klaus
KS>> -- 






-- 
Best regards,
 micael                            mailto:micael.beronius@telia.com



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.