[vdr] Re: split up channels.conf

["Rene Bartsch" <vdr@bartschnet.de>]

----- Original Message -----
From: "Klaus Schmidinger" <Klaus.Schmidinger@cadsoft.de>
To: <vdr@linuxtv.org>
Sent: Friday, September 27, 2002 7:07 PM
Subject: [vdr] Re: split up channels.conf


> Rene Bartsch wrote:
> >
> > > > How are you going to decide between LNB A,B,C, ...?
> > >
> > > The parameters 'source', 'frequency' and 'polarization' will be used
to
> > > look up an entry in the new file 'diseqc.conf', which will define the
> > entire
> > > DiSEqC sequence to send for this combination of the three parameters,
as
> > > well as the LOF to be used.
> >
> > Do you mean we can define different LOFs for any DVB-card?
> > This would make it possible to use VDR with frequency-shifting
single-cable
> > solutions!
>
> If I understand it correctly, a frequency-shifting single-cable solution
would require
> separate LOFs for each of the four combinations of low/hor, low/ver,
hi/hor and hi/ver,
> right? The mechanism I have in mind would be flexible enough to support
that.
>

I don't know if we need separate LOFs for each combination.
When I called Technisat because of the DisiCon-LNB I was told a receiver
would need a Diseq-menue to define a seperate LOF for any receiver.
I'll send an email to Technisat and ask for further information ...

Rene



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.