[vdr] Re: vdr-xine-plugin 0.0.2 problem, Micael Beronius

[Micael Beronius <micael.beronius@telia.com>]

Thanks,
This cleanly fixed it!

One thing though, (are you experiencing the same?) after switching channel, I 
need to hit pause for the fifo to fill up a bit to avoid stutter.

I will do further testing tonight ..

  - Micael

On Friday 14 November 2003 17.18, Jerome Bonnet wrote:
>JB_Sorry, this is my first post to the mailing list, I cannot reply
>JB_directly to the message.
>JB_
>JB_The referred subject was the xine plugin problem reported by Micael
>JB_Beronius.
>JB_The plugin do not send any data to xine even if it seems to work
>JB_properly.
>JB_The same problem happens with the xineliboutput plugin. This is due to
>JB_the fact that vdr supports only one primary DVB device (i.e. a device
>JB_with an mpeg2 decoder). The plugin emulates an mpeg2 decoder board but
>JB_sends the mpeg2 flux to xine. If you have a full-featured dvb card (with
>JB_mpeg2 hardware decoding), the flux is sent to this card by default,
>JB_instead of being sent to the plugin.
>JB_
>JB_The solution is to edit the setup.conf and set PrimaryDVB=2 (that is 2
>JB_if you have one dvb hardware card that takes the first slot).
>JB_
>JB_Seems to work now, even if I suffer some segmentation fault when
>JB_switching channels too often.
>JB_



-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.