[linux-dvb] Re: driver 0.9.4, network activator and OpenSky

[Milan Kecman <mkecman@pogled.net>]

Hi,

I had /dev/video as directory, so dvbd didn't start because ot that.

Now it starts, first line sais sync 64 or 96, and after that any other output is sync=0, and
ping to EON proxy does not work.

After I stop dvbd, i cant do modprobe -r dvb, get the message devise or resource is busy.

dvbd puts the following in the logfile:

Feb 19 09:25:43 proxy dvbd[1492]: reading config
Feb 19 09:25:43 proxy dvbd[1492]: IP(net) for filter_0 is x.y.z.w/255.255.
255.255
Feb 19 09:25:43 proxy dvbd[1492]: activating
This part is working, but I've set in /etc/dvbd.conf
v4l_ifname /dev/video0
is the video0 right device?

After I do modprobe dvb I hear on speakers sound from a channel No. 3.
After dvbd there is no sound.

Where should I look further?

Best regards
    Milan Kecman

Andrei Boros wrote:

> Milan Kecman wrote:
> >
> > I have compiled 0.8.2 vith patch-8, modprobe dvb loads the modules, i get no errors.
> > I compiled dvbd 3a, and when I run it, it just (I hope) does his job, and ends, not like
> > dvbd2  and dvbd3 whitch were displaying sync and other parameters.
> >
> > Is this correct behavior of dvbd3a?
> >
>
> No output at all? Or other/different output?
> Can you give me an example of the latter case if applicable?
>
> What appears in your system logs from dvbd?
>
> do you have /dev/video -> /dev/video0 devices?
>
> --
> ing. Andrei Boros
> mailto:andrei@srr.ro / +40-1-303-1870
> Centrul pt. Tehnologia Informatiei
> Societatea Romana de Radiodifuziune





-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.