[vdr] Re: 1.3.1 and Conax not working

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Jan Ekholm wrote:
> 
> On Fri, 16 Jan 2004, Klaus Schmidinger wrote:
> 
> >Jan Ekholm wrote:
> 
> <Conax problems>
> 
> >> Once I did get a single still frame shown when switching to an encrypted
> >> channel, so something is kind of working.
> >>
> >> Anything particular that should be tested/debugged or is it better to
> >> revert to 1.2.6 for now?
> >
> >You could enable the debug output in VDR/ci.c in both versions and
> >try to compare the data that is sent to the CAM. Version 1.3.1 has some
> >changes regarding CAM access, but they were supposed to make things better,
> >not worse...
> 
> I enabled the debugging and got the following results. The two files are
> made as links as they are fairly long:
> 
> http://www.infa.abo.fi/~chakie/media/dvb/debug-1.2.6pre4.txt
> http://www.infa.abo.fi/~chakie/media/dvb/debug-1.3.2.txt
> 
> 1.2.6pre4 works fine. I did some channel changes within the encrypted
> channels and then finished by changing to a FTA channel.
> 
> 1.3.2 shows a black screen (but EPG works fine) for all encrypted
> channels. I switched two or three times. The debug output is basically
> just the same line over and over again, even when channels were switched.
> 
> Is this of any help, or would you like more "scientific" debugging?

Apparently there are no CA descriptors sent to the CAM in 1.3.2.

Please post the channels.conf entry for one of the channels that
works in 1.2.6, but doesn't work in 1.3.

Klaus


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.