[linux-dvb] Re: Full featured card summary

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Johannes Stezenbach wrote:
> 
> Klaus Schmidinger wrote:
> > Holger Waechtler wrote:
> > >
> > > On Sunday 14 March 2004 23:55, Andrew de Quincey wrote:
> > > >
> > > > The problem with 1.1.0 is VDR isn't doing the full DISEQC init sequence,
> > > > and so no voltage was ever being sent to the LNB.
> > >
> > > that's definitely illegal.
> >
> > Note that I _do_ turn on LNB power now when setting up the devices in VDR.
> 
> Just to make sure: You also must wait some msec after turning
> the power on before sending the first DiSEqC command.
> 
> Johannes

This is implicitly the case because first the devices are initialized
one by one, and then (a few seconds later) the first actual channel
switch occurs.

Besides, even with the DiSEqC setup

S19.2E  11700 V  9750  t v W15 [E0 10 38 F0] W15 A W15 t
S19.2E  99999 V 10600  t v W15 [E0 10 38 F1] W15 A W15 T
S19.2E  11700 H  9750  t V W15 [E0 10 38 F2] W15 A W15 t
S19.2E  99999 H 10600  t V W15 [E0 10 38 F3] W15 A W15 T

(which definitely explicitly waits 15ms before sending any
DiSEqC sequence) it doesn't work (see my reply to Holger's
mail).

Klaus


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.