[vdr] Re: SV: CAM support, was Improved CAM support in VDR

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Nils Olav Fossum wrote:
> 
> lør, 2003-01-11 kl. 18:07 skrev micael.beronius@telia.com:
> 
> > Also I get no response. (only --> 00 01 82 01 01)
> >
> > I am using a viaccess redline CAM, which works somewhat using the
> > old "built in" CI/CAM firmware. (Driver reloads are necessary most of
> > the time to get it working). I'm very optimistic about this CAM issue
> > being dealt with by vdr, since in reality vdr is not usable for me
> > with the current built in CAM stuff.
> >
> > Kernel 2.4.19
> > DVB-C 2.1
> > CI 3.5"(floppy) model Rev. 1.6          <- Could this be the common problem?
> 
> Same here, :-/
> 
> Hauppauge WinTV DVB-S Rev 2.1 and CI 3.5"(floppy) model Rev. 1.6
> 
> After checking in windoze that my hardware is OK,
> the last channel I watched before reboot is decrypted in vdr :-)

No wonder, since VDR apparently doesn't get connected to the CAM it
can't tell it to decrypt something different. And since the driver
itself doesn't send any CA_PMT data to the CAM any more a scenario
as you describe it is possible.

> I guess it will not survive a coldboot..

Probably not.

> ..will not check this now, I had enough reboots for today.

When doing so, please try my latest ftp://ftp.cadsoft.de/pub/etc/ci.c.
This one sends the initial T_CREATE_TC several times.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.