[vdr] Re: SV: CAM support, was Improved CAM support in VDR

[Nils Olav Fossum <nfossum@online.no>]

lør, 2003-01-11 kl. 21:06 skrev Klaus Schmidinger:
> Nils Olav Fossum wrote:
> > 
> > lør, 2003-01-11 kl. 18:07 skrev micael.beronius@telia.com:
> > 
> > > Also I get no response. (only --> 00 01 82 01 01)
> > >
> > > I am using a viaccess redline CAM, which works somewhat using the
> > > old "built in" CI/CAM firmware. (Driver reloads are necessary most of
> > > the time to get it working). I'm very optimistic about this CAM issue
> > > being dealt with by vdr, since in reality vdr is not usable for me
> > > with the current built in CAM stuff.
> > >
> > > Kernel 2.4.19
> > > DVB-C 2.1
> > > CI 3.5"(floppy) model Rev. 1.6          <- Could this be the common problem?
> > 
> > Same here, :-/
> > 
> > Hauppauge WinTV DVB-S Rev 2.1 and CI 3.5"(floppy) model Rev. 1.6
> > 
> > After checking in windoze that my hardware is OK,
> > the last channel I watched before reboot is decrypted in vdr :-)
> 
> No wonder, since VDR apparently doesn't get connected to the CAM it
> can't tell it to decrypt something different. And since the driver
> itself doesn't send any CA_PMT data to the CAM any more a scenario
> as you describe it is possible.
> 
> > I guess it will not survive a coldboot..
> 
> Probably not.
> 
> > ..will not check this now, I had enough reboots for today.
> 
> When doing so, please try my latest ftp://ftp.cadsoft.de/pub/etc/ci.c.

I did use that.. 
but right now the foldet is empty :-)

-- 
Mvh
Nils Olav Fossum



--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.